In advanced integrated circuit manufacturing processes, the quality of chemical mechanical flattening is a key factor affecting chip performance and yield. Therefore, it has become increasingly important to develop an accurate predictive model for the chip surface topography after chemical mechanical flattening. In the modeling process, the noise problem of atomic force microscopy measurement data is relatively serious. To solve this problem, the noise characteristics of atomic force microscope measurement data for chip surface topography in this field are studied and discussed in this paper. It is found that the noise present in such problems is mainly triggered by the vibration and tilt of the probe. Two types of noise, low-frequency and high-frequency, are presented in the time domain. In order to solve the noise problem in this modeling data, this paper analyzes the spectral characteristics of the measurement data using Fourier transform, and a wavelet-Fourier transform composite noise reduction process is proposed. The algorithm is applied to the noise reduction of the chip surface data of 32 nm copper interconnect process. The noise reduction results were compared with scanning electron microscope photographs to verify the effectiveness of the noise reduction.
As a planarization technique, chemical mechanical polishing (CMP) continues to suffer from pattern effects that result in large variations in material thickness, which can influence circuit performance and yield. Therefore, tools for predicting post-CMP chip morphology based on the layout-dependent effect (LDE) have become increasingly critical and widely utilized for design verification and manufacturing development. In order to characterize the impact of patterns on polishing, such models often require the extraction of graphic parameters. However, existing extraction algorithms provide a limited description of the interaction effect between layout patterns. To address this problem, we calculate the average density as a density correction and innovatively use a one-dimensional line contact deformation profile as a weighting function. To verify our hypothesis, the density correction method is applied to a density step-height-based high-K metal gate-CMP prediction model. The surface prediction results before and after optimization are compared with the silicon data. The results show a reduction in mean squared error (MSE) of 40.1% and 35.2% in oxide and Al height predictions, respectively, compared with the preoptimization results, confirming that the optimization method can improve the prediction accuracy of the model.
Automatic Classification of Wireless Signals (ACWS), which is an intermediate step between signal detection and demodulation, is investigated in this paper. ACWS plays a crucial role in several military and non-military applications, by identifying interference sources and adversary attacks, to achieve efficient radio spectrum management. The performance of traditional feature-based (FB) classification approaches is limited due to their specific input feature set, which in turn results in poor generalization under unknown conditions. Therefore, in this paper, a novel feature-based classifier Neural-Induced Support Vector Machine (NSVM) is proposed, in which the features are learned automatically from raw input signals using Convolutional Neural Networks (CNN). The output of NSVM is given by a Gaussian Support Vector Machine (SVM), which takes the features learned by CNN as its input. The proposed scheme NSVM is trained as a single architecture, and in this way, it learns to minimize a margin-based loss instead of cross-entropy loss. The proposed scheme NSVM outperforms the traditional softmax-based CNN modulation classifier by managing faster convergence of accuracy and loss curves during training. Furthermore, the robustness of the NSVM classifier is verified by extensive simulation experiments under the presence of several non-ideal real-world channel impairments over a range of signal-to-noise ratio (SNR) values. The performance of NSVM is remarkable in classifying wireless signals, such as at low signal-to-noise ratio (SNR), the overall averaged classification accuracy is > 97% at SNR = −2 dB and at higher SNR it achieves overall classification accuracy at > 99%, when SNR = 10 dB. In addition to that, the analytical comparison with other studies shows the performance of NSVM is superior over a range of settings.