For reliability and thermal management of power devices, the most frequently used technique is to employ heatsinks. In this work, a new configuration of offset strip fin heatsink based on using the concept of curvy fins and U-turn is proposed with the aim of improving the heat transfer performance. With this aim, a three-dimensional model of heatsink with Silicon Insulated-Gate Bipolar Transistors (IGBTs) and diodes, solder, Direct Bonded Copper (DBC) substrate, baseplate and thermal grease is developed. Richardson’s extrapolation is used for increasing the accuracy of the numerical simulations and to validate the simulations. To study the effectiveness of the new offset design, results are compared with conventional offset strip fin heatsink. Results show that in aspects of design of heatsinks (including heat transfer coefficient, maximum chip temperature and thermal resistance), the new introduced model has advantages compared to the conventional offset strip fin design. These enhancements are caused by the combination of the longer coolant passage in the heatsink associated with generation of disturbance and recirculation areas along the curvy fins, creation of centrifugal forces in the U-turn, and periodic breaking up boundary layers. Also, it is shown that due to narrower passage and back-and-forth route, the new introduced design can handle the hot spots better than conventional design.
16 May 2024 in Colloids and Surfaces A: Physicochemical and Engineering Aspects
A benchmark study is conducted using isoAdvection as the interface description method. In different studies for the simulation of the thermal phase change of nanofluids, the Volume of Fluid (VOF) method is a contemporary standard to locate the interface position. One of the main drawbacks of VOF is the smearing of the interface, leading to the generation of spurious flows. To solve this problem, the VOF method can be supplemented with a recently introduced geometric method called isoAdvection. We study four benchmark cases that show how isoAdvection affects the simulation results and expose its relative strengths and weaknesses in different scenarios. Comparisons are made with VOF employing the Multidimensional Universal Limiter for Explicit Solution (MULES) limiter and analytical data and experimental correlations. The impact of nanoparticles on the base fluid are considered using empirical equations from the literature. The benchmark cases are 1D and 2D boiling and condensation problems. Their results show that isoAdvection (with isoAlpha reconstruct scheme) delivers a faster solution than MULES while maintaining nearly the same accuracy and convergence rate in the majority of thermal phase change scenarios.
Simulations of thermally driven phase change phenomena of nanofluids are still in their infancy. Locating the gas–liquid interface location as precisely as possible is one of the primary problems in simulating such flows. The VOF method is the most applied interface description method in commercial and open-source CFD software to simulate nanofluids’ thermal phase change. Using the VOF method directs to inaccurate curvature calculation, which drives artificial flows (numerical non-physical velocities), especially in the vicinity of the gas–liquid interface. To recover accuracy in simulation results by VOF, a solver coupling VOF with the level-set interface description method can be used, in which the VOF is employed to capture the interface since it is a mass conserving method and the level-set is employed to calculate the curvature and physical quantities near the interface. We implemented the aforementioned coupled level-set and VOF (CLSVOF) method within the open-source OpenFOAM framework and conducted a comparative analysis between CLSVOF and VOF (the default interface capturing method) to demonstrate the CLSVOF method’s advantages and disadvantages in various phase change scenarios. Using experimental mathematical correlations from the literature, we consider the effect of nanoparticles on the base fluid. Results shows that the new inferred technique provides more precise curvature calculation and greater agreement between simulated and analytical/benchmark solutions, but at the expense of processing time.