The high-density polyethylene (HDPE) double-wall corrugated pipe, which is a kind of flexible pipe, is widely used in municipal drainage networks. The characteristics of the surrounding soil and pipe bed, pipe cover depth, backfill compaction, type of pavement and pavement design, and traffic loads are some of the major factors that affect the stress and deformation of pipes. In this study, the ABAQUS 3D finite element model was used to analyze the influence of backfill compactness, traffic loads, diameter, and hoop stiffness on the mechanical characteristic of an HDPE pipe under traffic loads. A series of full-scale tests were carried out to verify the validity of the simulation results. For the conditions tested, the results showed the following: (1) the Von-Mises stress of the pipe was mainly determined by the earth pressure at the crown, and the stress caused by backfill compaction increased significantly but had a short duration and limited impact on the pipe; (2) traffic load alone had little influence on the mechanical behavior of the pipe: while under the action of the loose backfill in contact with the pipe, the pipes were more sensitive to the traffic load response; (3) the fluctuations in the Von-Mises stress of the pipe mainly depended on the magnitude and speed of the traffic load; (4) for pipes with a small diameter, non-compacted backfill easily caused stress concentration in the pipe, while the degree of backfill compaction had almost the same effect on the distribution of stress for pipes with different hoop stiffness.

Cured-In-Place-Pipe (CIPP) rehabilitation technology is widely utilized in pipeline rehabilitation projects and has exhibited favorable results. Nevertheless, the mechanical characteristics of pipelines after CIPP rehabilitation and the effectiveness of CIPP rehabilitation in repairing these mechanical characteristics remain unknown. To address these issues, a three-dimensional numerical model of a corroded concrete pipe before and after CIPP rehabilitation was established in the present study. To authenticate the accuracy of the numerical model, the numerical simulation data were compared with the full-scale test data from prior research, and the comparison outcomes show that the numerical model formulated in this study is reasonable and reliable. To appraise the repair effectiveness of CIPP rehabilitation, the mechanical properties of a corroded pipe, a CIPP-repaired pipe, and a normal pipe under traffic load were computed and compared, and the comparison outcomes demonstrate that the stress in the pipe bell, stress in the pipe spigot, vertical displacement of the pipe crown, and vertical displacement of the pipe invert were reduced by 39.8%, 16.7%, 24.7%, and 24.4%, respectively, after CIPP rehabilitation. Moreover, a series of three-dimensional numerical models were constructed to scrutinize the impacts of factors such as corrosion degree, corrosion angle, and traffic load on the mechanical properties of corroded pipelines before and after CIPP rehabilitation. The findings indicate that the stress on the pipe escalates with increasing corrosion degrees and diminishes with increasing corrosion angles; there are no noteworthy differences between the vertical displacement of the pipe and the von Mises stress of the CIPP liner for diverse corrosion degrees and corrosion angles; the amplification of the traffic load will augment the stress and displacement of the pipe and increase the rotation of the pipe, resulting in a significant upsurge in the stress of the CIPP liner at pipe joints. When the traffic load magnitude rises from 0.7 MPa to 1 MPa, the stress and displacement of the pipe and the von Mises stress of the CIPP liner were increased by 18.9%, 42.3%, and 42.1%, respectively.