Titanium dioxide materials were synthesized using two different methods. The samples were characterized by X-ray diffraction (XRD), UV–Visible diffusion reflectance spectroscopy (UV-Vis DR), Raman spectroscopy, N2 adsorption/desorption, scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX), transmission electron spectroscopy (TEM) and X-ray photoelectron spectroscopy (XPS). Although both kind of materials were found to have mesoporous structure and anatase crystalline phase, one of them was obtained from a synthesis method that does not involve the use of surfactants, and therefore, does not require calcination at high temperatures. This implies that the synthesized solid was self-doped with carbon species, coming only from the same source used for titanium. Then, the relationship between the presence of these species, the final calcination temperature, and the photocatalytic activity of the solids was studied in terms of the degradation and mineralization of an Acid Orange 7 aqueous solution, under visible radiation. A photosensitizing effect caused by the non-metal presence, that allows the solid to extend its absorption range, was found. Hence, a novel route to prepare C-modified photoactive mesoporous TiO2, simpler and cheaper, where neither a template nor an external carbon source is used, could be performed.
Renewable p-xylene was successfully attained via aromatization reaction of bio-derived 2,5-DMF with ethylene over Al–Nb-SBA-15 mesoporous materials with enhanced acid properties.
Bimetallic mesoporous photocatalysts were synthesized via a wet impregnation method using SBA-15 as a support, and characterized by UV–visible diffuse reflectance spectroscopy, low-angle X-ray diffraction and N2 physisorption. Among the tested materials, the Ti/Mn combination exhibited the highest photocatalytic activity in azo dye degradation. To understand this enhanced performance, catalysts with varying Mn loads and calcination ramps were evaluated. Additionally, experiments with radical scavengers (isopropanol, chloroform) and under N2 insufflation were conducted to identify the active radical species. Catalysts prepared with low Mn content and higher calcination ramps showed the greatest activity, which significantly decreased with isopropanol, indicating hydroxyl radicals as the main reactive species. In contrast, samples with higher Mn content and quicker heating displayed reduced activity in the presence of chloroform, suggesting superoxide radical involvement. Spectroscopic analyses (XPS, UV–Vis DRS) revealed that increasing Mn load promotes the formation of Mn2+ over Mn4+ species and lowers the band gap energy. These findings highlight the direct correlation between synthesis parameters, surface composition and optical properties, providing a strategy for fine-tuning the performance of a photocatalyst.
15 January 2025 in Results in Surfaces and Interfaces