A novel high breakdown voltage (BV) AlGaN/GaN high‐electron mobility transistor (HEMT) with a high‐K/low‐K compound passivation layer is proposed. The compound passivation layer is formed by blocks of low‐K dielectric (Si 3 N 4 ) embedded in a high‐K passivation layer (La 2 O 3 ). Owing to their different dielectric constants, there is a discontinuity of the horizontal electrical field at the high‐K/low‐K interface, which can introduce a new electric field peak in the nearby channel in the semiconductor and can also modulate the distribution of the electric field along the channel. Hence, enhancement of BV can be achieved. Compared to the typical field‐plate structure, high‐K/low‐K passivation introduces no parasitic capacitance. On the basis of the physical mechanism, several design principles for the high‐K/low‐K passivation layer are presented. Numerical simulation demonstrates a BV of 1400 V for the proposed device with four blocks of low‐K dielectric embedded in a high‐K passivation, compared to the BVs of 917 and 288 V for the device with high‐K passivation and the device with low‐K passivation, respectively.
A gate length of 0.2 μm InAlN/GaN high electron mobility transistor on SiC substrate is obtained with a maximum current gain cutoff frequency (fT) of 65.8 GHz and a maximum power gain cutoff frequency (fmax) of 143.6 GHz. Lombardi model, which takes interface roughness scattering into consideration, has been introduced to model the transconductance (gm) degradation. The simulated gm and fT with Lombardi model are 69% and 58% lower than the ones without considering interface roughness scattering, respectively. Further analysis show experimental gm, gate capacitance (Cg), and fT are consistent with results based on Lombardi model.
A novel reduced surface field (RESURF) AlGaN/GaN high electron mobility transistor (HEMT) with back electrode is proposed. The back electrode is electrically grounded and attached to the AlN nucleation layer after the substrate is removed. The back electrode, which attracts the electric field lines at the AlGaN/GaN interface by inducing negative charges, leads to a more uniform horizontal electric field along the channel and, hence, a significant improvement in breakdown voltage. Meanwhile, there is negligible negative impact on the ON‐state resistance. Numerical simulation demonstrates a breakdown voltage of 1701 V and an ON‐state resistance of 10.45 Ω mm with a gate–drain spacing of 6 μm for the proposed device, compared to a breakdown voltage of 1118 V and an ON‐state resistance of 10.34 Ω mm for conventional RESURF AlGaN/GaN HEMT.