The dewatering of deep foundation pits excavated in highly permeable geology usually requires waterproofing technologies to relieve groundwater flow. However, no effective prediction formula is yet available for determining water inflow in the presence of partial penetrating curtains. In this study, a dewatering project with partial penetrating curtains is analyzed via a finite difference method to show evident three-dimensional (3D) seepage characteristics. The standard curve and distortion functions are established under the assumption of an equivalent well by quantifying the blocking effects; thus, the empirical inflow prediction formulas for steady flow are further developed. Moreover, a dewatering design method based on the prediction formulas is proposed and applied to the field dewatering project in sand and gravel strata. Measured results show that dewatering efficiency is considerably enhanced by 3D flow, forming appropriate pressure distributions for dewatering construction. The uplift pressure below the pit bottom is controlled within a 25% safety margin to verify the reliability of the design method.

Notched beam specimens were loaded by the three-point bending test device, and the effects of different volume contents and combinations of steel fibers on the tensile properties of hybrid steel fiber–reinforced self-compacting concrete (HSFRSCC) were studied. The failure law and strain field distribution of the specimens were studied by digital image correlation (DIC) technology. Moreover, the curves between the load and crack mouth opening displacement (CMOD) of 18 groups of hybrid steel fiber–reinforced concrete specimens were obtained, and the stress–strain curves of 18 groups of specimens were derived from the load–CMOD curves. The results show that both single and hybrid steel fibers can improve the crack deformation resistance and tensile properties of concrete, but hybrid steel fibers have a more significant improvement effect. Only when the content of steel fiber is more than 0.6% can it have a more obvious postpeak descending section, and hybrid steel fiber has higher postpeak deformation capacity and flexural toughness. The fundamental reason why concrete with hybrid steel fibers has better tensile properties is that micro and macro steel fibers cooperate with each other to resist cracks, improving the toughness of concrete after cracking. Finally, the mechanism of different size and volume content of steel fiber was analyzed from the micro level, which can be used as a reference for the engineering design of HSFRSCC in the future.

The weak interlayer, as a problematic geological body during tunnel construction, greatly influences the propagation of the blasting stress wave, the blasting excavation qualities, and the explosion efficiency. A series of numerical models were established to study the changes in the propagation process of blasting stress waves and the failure morphology of the surrounding rock mass, aiming to reveal the weak interlayer’s influence mechanism. The result indicates that the weak interlayer’s existence reduces the propagation velocity and stress peak of the stress wave at barred zones but strengthens the peak stress at reflection zones, which leads to an asymmetrical distribution of rock damage. Furthermore, the type and distribution of the weak interlayer were classified and generalized into four types. The tunnel blasting outlines under different types of weak interlayers are derived through numerical modeling for designing references. A strategy to resist tunnel overbreak and underbreak was proposed combined with previous work. The actual blasting solution is compared to the designed blasting solution with optimised blasting parameters.

At present, jet-grouted horizontal waterproof curtain reinforcement has become an essential method for deep foundation pit groundwater control. However, there is still a lack of an effective theoretical calculation method for horizontal waterproof curtain reinforcement, and there is little research on the seepage laws of foundation pits under different horizontal waterproof curtain conditions. Based on Darcy’s seepage theory, theoretical analysis models of deep foundation pit seepage were established considering the effect of a horizontal curtain in a highly permeable formation. Through the established models, the calculation method of the water inflow and the water pressure under the condition of a horizontal curtain was derived. Then through indoor tests, the reliability of the theoretical calculation method was verified. Furthermore, the established theoretical calculation method is used to analyze the influence of various factors on the water inflow and the water pressure, such as the ratio of hydraulic conductivity of the horizontal curtain to surrounding soil, thickness, and reinforcement position of the horizontal curtain. It is found that the hydraulic conductivity ratio has the most significant influence on the seepage characteristics of the foundation pit. Finally, the design method was applied to an example of the horizontal waterproof curtain of the foundation pit, which is located at Juyuanzhou Station in Fuzhou (China). The water inflow per unit area is 0.36 m³/d in the foundation pit, and this implies that the design method of the horizontal waterproof curtain applied for the excavation case is good and meets the requirements of design and safety.

This paper performs an extensive literature survey and example investigation on the stabilisation of slurry wall trenches during the construction of diaphragm wall panel trenches, and the failure modes of slurry wall trench instability, the stability theoretical analysis models and methods, the slurry formation and its protection mechanism, the influence of related factors on slurry wall trench stabilisation, and other related problems are summarized and analyzed emphatically. And then, based on the limit equilibrium analysis method, the mechanical models of the overall stability and local stability of the trench wall are established, respectively, and the design method of slurry unit weight is derived to ensure the stability of the trench wall. Furthermore, an example application shows that the established slurry unit weight design method is reliable. At last, this paper also proposes the focus and direction for follow‐up work, that is, to construct an accurate and effective theoretical analysis model of slurry wall trench instability considering the influence of multiple factors and the calculation method of the slurry cake and its mechanical or mathematical relationship with slurry quality.