Vertical-cavity surface-emitting lasers (VCSELs) yield single-longitudinal-mode operation, low-divergence circular output beam, and low threshold current. This paper gives an overview on theoretical, self-consistent modelling of physical phenomena occurring in a VCSEL. The model has been experimentally confirmed. We present versatile numerical methods for nitride, arsenide, and phosphide VCSELs emitting light at wavelengths varying from violet to near infrared. We also discuss different designs with respect to optical confinement: gain guidance using tunnel junctions and index guidance using oxide confinement or photonic crystal and we focus on the problem of single-transverse-mode operation.
We show that a change to the quality (Q) factor of a laser diode cavity affects the electrical properties of the device. The mechanism is demonstrated experimentally and numerically via a 980-nm InGaAs/GaAs oxide-aperture vertical-cavity surface-emitting laser (VCSEL) wherewith thin, sub-half-lambda-thick Six Ny layers are deposited on top of the VCSEL's top-coupling distributed Bragg reflector (DBR) mirror to modify the DBR's power reflectance. The presence of such a mechanism enables the detection of a substance that rests on or is in close proximity to the exposed DBR when the substance modifies the Q factor of the laser diode. As an example, we numerically analyze the influence of the change of the refractive index and absorption of a substance in the proximity of a 1651-nm AlInGaAs/InP VCSEL with a top mirror in the form of a monolithic subwavelength high-index contrast grating (MHCG). Such a design enables the detection of methane near the MHCG by changing the properties of the resonating light in the proximity of the grating. We show that this sensing mechanism enables the construction of a new compact optical sensing system without the need for a photodetector.
In this paper, we consider several designs for nitride-based vertical-cavity surface-emitting lasers (VCSELs) with a top semiconductor-metal subwavelength grating (SMSG) as the facet mirror. The constructions of the bottom distributed Bragg reflectors (DBRs) used in the VCSEL designs were inspired by devices demonstrated recently by several research groups. A multiparameter numerical analysis was performed, based on self-consistent thermal and electrical simulations. The results show that, in the case of small aperture VCSEL designs, dielectric-based DBRs with metallic or GaN channels enable equally efficient heat dissipation to designs with monolithically integrated DBRs. In the case of broad aperture designs enabled by SMSGs, monolithically integrated DBRs provide much more efficient heat dissipation in comparison to all other considered designs.
15 October 2007 in IEEE Journal of Quantum Electronics
Threshold characteristics of GaAs-based 650-nm gallium indium phosphide (GalnP) vertical-cavity surface-emitting diode lasers (VCSELs) with two different optical confinement structures are investigated with the aid of a self-consistent, fully-physical VCSEL model. Efficacy of the optical confinement introduced by the oxide aperture is compared with an alternative single-defect photonic-crystal design with holes etched throughout the whole VCSEL. Initially, photonic-crystal VCSEL reveals 10% lower threshold electrical power than that of the analogous oxide-confined VCSEL. Further optimization of the current injection allows for an additional 20% threshold reduction. The photonic-crystal confinement concept appears to be a very prospective solution for VCSEL configurations, for which oxidation is unfeasible, e.g., for possible nitride or phosphide VCSELs.