This paper investigates control-oriented modeling of a class of wireless power transfer systems with a phase-shift controlled inverter. Two methods are studied: the conventional analytical modeling method which is based on physical laws, and the refined instrumental variable method which is based on sampled data. It shows that the former provides good physical insights into the system, and that the resulting models are accurate when the true circuit component parameters are known. However, poor results may be obtained if this condition is not satisfied. By contrast, the later provides a cheap solution for accurate modeling, which requires a set of sampled input-output data only and the resulting model can capture very well the dynamic behavior of the system within its operating range. To have virtues of both methods, it is therefore suggested to use them as a combination, that is, using the analytical method to determine the model order while using the data-driven method to estimate the model parameters. All results derived in this paper are verified by means of both numerical simulation and experimental validation.
The fault-tolerant control (FTC) of heavy-haul trains is discussed on the basis of the speed regulation proposed in previous works. The fault modes of trains are assumed and the corresponding fault detection and isolation (FDI) are studied. The FDI of sensor faults is based on a geometric approach for residual generators. The FDI of a braking system is based on the observation of the steady-state speed. From the difference of the steady-state speeds between the fault system and the faultless system, one can get fault information. Simulation tests were conducted on the suitability of the FDIs and the redesigned speed regulators. It is shown that the proposed FTC does not explicitly worsen the performance of the speed regulator in the case of a faultless system, while it obviously improves the performance of the speed regulator in the case of a faulty system.
1 June 2018 in International Journal of Electrical Power & Energy Systems
This paper studies the control strategy for adaptive cruise control (ACC) system on a battery electric vehicle (BEV) in the car‐following process, and the highlight of this paper is that the regeneration braking of BEV is considered in the car‐following process. The hierarchical control structure is adopted for the ACC system. And the structure contains an upper controller and a lower controller. In the upper controller, multiple objectives including the safety, tracking, comfort, and energy consumption are optimized by using the model predictive control (MPC) method. In the lower controller, the energy is recovered during braking. So the energy economy is improved by reducing energy consumption and increasing energy recovery. The proposed ACC strategy is evaluated in simulation experiment. In the simulation experiment, safe tracking for the front vehicle is guaranteed, and the comfort and the energy economy are improved greatly. So the proposed adaptive cruise control strategy can make ACC more widely used in BEVs.
This paper introduces a model-free optimization method based on reinforcement learning (RL) aimed at resolving the issues of active power and frequency oscillations present in a traditional virtual synchronous generator (VSG). The RL agent utilizes the active power and frequency response of the VSG as state information inputs and generates actions to adjust the virtual inertia and damping coefficients for an optimal response. Distinctively, this study incorporates a setting-time term into the reward function design, alongside power and frequency deviations, to avoid prolonged system transients due to over-optimization. The soft actor critic (SAC) algorithm is utilized to determine the optimal strategy. SAC, being model-free with fast convergence, avoids policy overestimation bias, thus achieving superior convergence results. Finally, the proposed method is validated through MATLAB/Simulink simulation. Compared to other approaches, this method more effectively suppresses oscillations in active power and frequency and significantly reduces the setting time.