Maciej Petko

Prof. Maciej Petko

orcid

Research Focus & Metrics

Academic Career Length

33Years (1994-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 2016 in Mechatronics
Verified
Journal Article
Closed access
MPMaciej Petko
Maciej Petko
KGKonrad Gac
Konrad Gac
GGGrzegorz Góra
Grzegorz Góra
GKGrzegorz Karpiel
Grzegorz Karpiel
JOJanusz Ochoński
Janusz Ochoński
KKKonrad Kobus
Konrad Kobus

1 August 2016 in Mechatronics
Verified
Journal Article
Closed access
MPMaciej Petko
Maciej Petko
GKGrzegorz Karpiel
Grzegorz Karpiel
KGKonrad Gac
Konrad Gac
GGGrzegorz Góra
Grzegorz Góra
KKKonrad Kobus
Konrad Kobus
JOJanusz Ochoński
Janusz Ochoński

1 September 2012
Verified
Conference Paper
Closed access
KGKonrad Gac
Konrad Gac
GKGrzegorz Karpiel
Grzegorz Karpiel
MPMaciej Petko
Maciej Petko
The paper presents an application of field programmable gate arrays (FPGA) to support the calculation of the inverse kinematics problem of a parallel robot. The presented robot is designed for milling by moving the spindle along a desired trajectory generated in the Cartesian space. This means that for each point of the trajectory a solution of the inverse kinematics problem is needed. The resulting sequence of data creates the joint space trajectory that must be calculated on-line at high frequency. The paper shows how to decrease the calculation time preserving required accuracy, by augmenting the arithmetic-logic unit (ALU) of a microprocessor with custom instructions. The hardware implementation of the accelerator is described and results of calculations performed in an Altera FPGA chip are analyzed.

1 January 2008 in Shock and Vibration
Verified
Journal Article
Open access
PDF file
Tadeusz UhlTadeusz Uhl
Tadeusz Uhl
MPMaciej Petko
Maciej Petko
GKGrzegorz Karpiel
Grzegorz Karpiel
AKAndrzej Klepka
Andrzej Klepka
In this paper the recursive method for modal parameters estimation is formulated and verified. Formulated algorithms are implemented in the FPGA electronic chip. As a result, the modal parameters and confidence bounds for the modal parameters are obtained in real time. The algorithms and their implementations are tested on laboratory test rig data and applied to – flight modal analysis of an airframe structure.


11 October 2006
Verified
Conference Paper
Closed access
MPMaciej Petko
Maciej Petko
GKG. Karpiel
G. Karpiel
The paper presents the process of development of parallel manipulators for milling, and justifies why mechatronic approach can lead to successes. The resulting construction is a novel, versatile 3-RRPRR (revolute-revolute-prismatic-revolute-revolute joints), fully-parallel manipulator with three translational degrees of freedom, characterizing in comparatively high payload capacity, large workspace and high attainable accelerations. The construction of the manipulator is shown, with analysis of its kinematics and dynamics. An initial controller for identification is proposed, simulated and experimentally investigated. Finally, the conclusions are presented