This article deals with power line communication (PLC) in the context of invehicle data networks. This technology can provide high-speed data connectivity via the exploitation of the existing power network, with clear potential benefits in terms of cost and weight reduction. The focus is on two scenarios: an electric car (EC) and a cruise ship. An overview of the wiring infrastructure and the network topology in these two scenarios is provided. The main findings reported in the literature related to the channel characteristics are reported. Noise is also assessed with emphasis on the EC context. New results from the statistical analysis of measurements made in a compact EC and in a large cruise ship are also shown. The channel characteristics are analyzed in terms of average channel gain (ACG), delay spread (DS), coherence bandwidth (CB), and achievable transmission rate. Finally, an overall comparison is made, highlighting similarities and differences while taking into account the conventional combustion engine car and the largely investigated in-home scenario.
15 February 2016 in IEEE Transactions on Circuits and Systems II: Express Briefs
Impedance matching plays an important role in a power-line-communication system. We investigate the effect on the signal-to-noise ratio at the receiver and on the system capacity of three different impedance matching criteria at the transmitter, assuming broad-band communication. We show that optimal impedance matching shall maximize the amplitude of the signal voltage at the channel input port. Since the line impedance exhibits highly frequency-dependent behavior, simplified impedance matching criteria are also proposed.
The use of power line communications (PLC) for the interconnection of devices inside vehicles is interesting because it can provide cost and weight reduction of the wiring harness. However, despite the compact size of the in-car electrical grid, high channel attenuation, low impedance access points, and high noise can limit the applicability of PLC. In this paper we report the results of a measurement campaign in a compact electrical car. We focus on the noise and channel response both in the narrow band range (30-500 kHz) and broad band range (2-100 MHz). We show that the electrical power drivers and DC/DC converters on board cause high noise which is more pronounced at low frequencies. Achievable rate analysis shows that the broad band spectrum is more suited for in-car PLC communications.
This paper analyzes the reciprocity, symmetry and port decoupling effect in real home PLC networks. The reciprocity has an impact on the fact that the input and output ports of a PLC link are decoupled, and the study on the symmetry can explain the reason for the decoupling effect. The analysis of experimental data in the band 2-100 MHz shows that the PLC channel is reciprocal and that the input-output ports are largely decoupled. In turn, the port decoupling property implies that impedance matching at the transmitter and receiver ports can be implemented independently one from the other. That is, the choice of the receiver impedance does not have effect on the choice of the transmitter impedance and vice versa, in home broad band PLC systems.
The paper proposes a methodology to model the impulse rate of sporadic impulsive noise, namely the impulsive noise that is generated by the transients during the on/off switching of electrical appliances. In particular, it is proposed to exploit the publicly available datasets of power consumption measurements campaigns to derive the instants when a switching on/off event occurs. The statistics of the impulse rate is derived considering the data gathered during a six-month measurement in one of the houses of the GREEND dataset. Furthermore, to define the set of appliances that generate sporadic impulsive noise within the considered house, a noise measurement campaign at the source the corresponding analysis was carried out.
In this paper, the effects of impedance matching in the PLC systems in terms of capacity are investigated. Two different matching methods at the transmitter port are introduced. Since the punctual impedance matching is a difficult task for the electronics, firstly we illustrate an algorithm useful to measure the input PLC channel impedance at both the transmitter and the receiver sides. This is of fundamental importance for the matching operations. Once the input impedances are retrieved, we compare the achievable system capacity obtainable with the transmitter impedance optimized applying the considered matching criteria. Furthermore, the channel capacity loss with simplified and more implementable transmitter impedance profiles are investigated.