Proper recording of thermophysical properties for molten salts (MSs) and molten salts based nanofluids (MSBNs) is of paramount importance for the thermal energy storage (TES) technology at concentrated solar power (CSP) plants. However, it is recognized by scientific and industrial communities to be non-trivial, because of molten salts creeping (scaling) inside a measuring crucible or a sample container. Here two strategies are proposed to solve the creeping problem of MSs and MSBNs for the benefit of such techniques as differential scanning calorimetry (DSC) and laser flash apparatus (LFA). The first strategy is the use of crucibles with rough inner surface. It was found that only nanoscale roughness solves the creeping problem, while micron-scale roughness does not affect the wetting phenomena considerably. The second strategy is the use of crucible made of or coated with a low-surface energy material. Both strategies resulted in contact angle of molten salt higher than 90° and as a result, repeatable measurements in correspondence to the literature data. The proposed methods can be used for other characterization techniques where the creeping of molten salts brings the uncertainty or/and unrepeatability of the measurements.
1 January 2022 in Solar Energy Materials and Solar Cells
The recovery and storage of process heat in industrial applications are some of the key factors to improve the sustainability and reliability of high temperature applications. In this sense, one of the main drawbacks is focused on the selection of proper thermal energy storage (TES) materials. This paper performs a full characterization of four phase change storage materials (PCM), KOH, LiOH, NaNO3 and KNO3, which are proposed for storage applications between 270 and 500 °C, according to the results obtained through differential scanning calorimeter and thermogravimetric analysis. One of the main innovations includes the corrosive evaluation of these materials in a promising alumina forming alloy (OC4), close to their corresponding phase change temperature during 500 h. The physicochemical properties obtained confirm the optimal use of NaNO3 and KNO3 and recommend the use, with caution, of KOH, due to its higher corrosive potential. FeCr2O4, NiCr2O4 and FeAl2O4 were the main protective spinels formed in the alloy surface, however, the cross-section study in the alloy immersed in KOH, revealed a non-uniform behavior, presenting some cracks and spallation in the surface. On the other hand, the proposal of LiOH was disregarded since it presents a narrow operation temperature range between melting and solidification point.
We demonstrate a method to calibrate a Shack–Hartmann sensor as an orthographic camera. This calibration method permits us to obtain the distance, the rotation matrix between the microlens array and CCD imaging planes, and the projection matrix, which models the projection of the incoming rays to the CCD imaging plane. The proposed calibration method introduces a very compact matrix notation and allows wavefront reconstruction without an explicit centroid search between the reference and distorted spot diagrams. We show a set of simulations in code V that prove the effectiveness of the proposed method.