The flow in the vaned diffuser of an aeronautical centrifugal compressor designed by Safran Helicopter Engines is analyzed through steady and unsteady pressure measurements at different rotation speeds. The analysis leads to the identification of different operating zones thanks to a new variable, the alternate rate $\mathcal{A}$. It allows the characterization of a specific behavior of the vaned diffuser consisting of an alternate stall pattern in two adjacent channels of the diffuser. While it is close to zero at low speed, the alternate rate reaches a maximum value at a higher speed before collapsing with a further increase in the rotation speed. Depending on the value reached by the alternate rate, three distinct regimes of the flow within the diffuser can be distinguished. For low $\mathcal{A}$ values, the regime is the most common one with an equivalent flow pattern in each channel of the diffuser. For moderate $\mathcal{A}$ values, a mild difference of the flow fields which develop in two adjacent channels can be observed but it remains time independent. Finally, for high values of $\mathcal{A}$, the alternate pattern is amplified and becomes time dependent, pulsating together with the mild surge of the entire compressor.

The present paper aims at providing an experimental analysis of the path to surge of a centrifugal compressor stage designed and built by Safran Helicopter Engines. Depending on the rotation speed of the compressor, two distinct flow patterns are observed in the radial diffuser at stabilized operating points near the surge, an asymmetric and a symmetric pattern. At medium rotation speed, the alternate pattern consisting of a two-channel pattern in the radial diffuser develops. One passage over two is stalled, the adjacent passage is free and this pattern replicates over the whole circumference while pulsing at a frequency of roughly 12 Hz which is close to the Helmholtz frequency of the test rig. By lowering the rotation speed, the two-channel pattern fades away and gives way to a periodical behavior of the radial diffuser passages called symmetric mode. The flow in each channel is identical presenting a stalled behavior pulsating in phase at a higher frequency of roughly 42 Hz. The two 12 Hz and 42 Hz modes are described and their existences are imputed to a lock-in of the natural frequencies of the instabilities with the acoustic modes of the test rig.

A centrifugal compressor stage designed and built by Safran Helicopter Engines is tested at several IGV (Inlet Guide Vanes) stagger angles. The compressor stage includes 4 blade rows: axial inlet guide vanes, a backswept splittered impeller, a splittered vaned radial diffuser and axial outlet guide vanes. More than a hundred steady pressure and temperature measurements are used for