Controlled-source electromagnetics is a strongly efficient technique to explore deep-water marine hydrocarbon reservoirs. However, the shallow-water unsolved limitations of electromagnetic shooting methods still exist. In this regard, this work aims to alter the existing conventional electromagnetic source such that it can converge the down-going electromagnetic wave while simultaneously dispersing the up-going electromagnetic energy to minimise the airwave in shallow water. This work presents computed electric current distribution inside a modified transmitter, using a method of moments. Simulation and an experiment-based methodology are applied to this work. Finite element simulation of the response of the modified transmitter displayed the capability of the new transmitter in dispersing the airwave, by 15%. The experimental setup confirmed a better performance of the new transmitter, showing hydrocarbon delineation of up to 48%, compared to the existing conventional transmitter, with 25% oil delineation at the same depths in the same environment. Modification of the electromagnetic source to unbalance the up-down signals may have the potential to enhance the delineation magnitude of the target signal and, as a result, significantly improve oil detection capability.

This research investigates the influence of various concentrations of BaTiO₃ nanofluid on adsorption energy and improved oil recovery. BaTiO₃ nanoparticles were successfully synthesized using a Sol-gel approach at temperatures of 400 °C, 500 °C, 800 °C, and 1000 °C and characterized for their structural and morphological properties and interfacial tension (IFT)/Wettability measurement. The study focuses on using ferroelectric nanofluid in combination with an electromagnetic field to enhance oil recovery mechanisms. Three concentrations of BaTiO₃ nanofluid were prepared, and their effects on pressure and recovery factors were examined. The results demonstrate that BaTiO₃ nanofluids increase the reservoir fluid’s ionic conductivity, leading to environmental polarization. Applying BaTiO₃ nanofluid on glass bead samples resulted in a significant 42.15% increase in the recovery factor at a 0.3% concentration in various measurements, including interfacial tension, core-flooding, and wettability. The nanofluid caused a reduction in interfacial tension and a shift in wettability from oil-wet to water-wet. The higher adsorption energy of the nanofluid corresponded to more significant oil recovery. The optimal concentration for maximum adsorption energy (−2.566331 × 10⁴) and oil recovery (22.5%) was 0.3wt%. At 0.1% concentration, the IFT value was 0.023 mN/m, at 0.3% concentration the IFT was 0.017 mN/m and at 0.5% concentration IFT value was 0.032 mN/m. The contact angle of the brine with the oil was 89.39% compared to the contact angle of 0.1%, 0.3%, and 0.5% which were 64.25%, 10.57%, and 44.63%, respectively. It was revealed from the result that 0.3% of nanofluid decreased the contact angle from 89.39% to 10.57 at a 0.3% concentration of BaTiO₃ nanofluid. This shows that the wettability of the rock surface changed from oil-wet to water-wet with the novel application of BaTiO₃ nanoparticles. This improvement in recovery can be attributed to the modification of wettability and reduction of interfacial tension.