The analysis of exhaled breath is important for health vs. disease diagnostics. Diagnosis and monitoring methods based on metal-oxide gas sensors are highly attractive, owing to their portability and ease of operation. These methods are non-invasive and affordable, and allow early disease diagnosis. Metal-oxide gas sensors are heat-resistant and can easily be combined with various nanostructures. We review concurrent research into metal-oxide gas sensors used to detect various biomarkers (e.g., acetone, nitric oxide, hydrogen sulfide, and ammonia) in the exhaled breath of humans. We also review efforts to improve the properties of metal-oxide gas sensors, especially structures, morphologies, the control of impurities in semiconductor materials, and changes in the specific surface area of metal-oxide materials that have been used in gas sensors to analyze exhaled breath. Various approaches to the humidity resistance characteristics and nonlinear responses of metal-oxide semiconductor gas sensors are addressed and should be applicable in real life.
In this work, a novel, highly sensitive and cost-effective sensing electrode was fabricated for the sensitive detection of bisphenol A in milk and water samples. An eco-catalyst Fe3O4–PEI nanocomposite was successfully synthesized using a hydrothermal method. XRD, XPS, TEM, FE-SEM, FTIR spectroscopy and a Zetasizer were employed to analyse the morphology, elemental composition and surface charge of the Fe3O4–PEI nanocomposite. A simple cyclic voltammetry technique was used for the sensitive detection of BPA on the Fe3O4–PEI/C electrode. The positive surface charge of the composite remarkably enhanced the sensitivity toward BPA. Under optimized conditions, the Fe3O4–PEI/C electrode showed high electrochemical sensitivity and good catalytic activity toward BPA. A wide linear sensitivity range from 0.01 μM to 50 μM with a high correlation coefficient of 0.99524 and a limit of detection (LOD) of 3.2 nM (S/N = 3) toward BPA were obtained for the Fe3O4–PEI/C electrode. The proposed electrode (Fe3O4–PEI/C) successfully detected BPA in milk and water samples with high recovery percentages of 100.9% and 100.5%, respectively. The results obtained using the proposed electrode (Fe3O4–PEI/C) correlated well with GC-MS data for real samples. A novel Fe3O4–PEI/C electrode exhibited high sensitivity, stability, and selectivity in BPA detection. Fe3O4–PEI/C shows high electrochemical activity toward 2,4-dinitrophenol as well. The proposed Fe3O4–PEI/C electrode is a highly convenient tool for the simultaneous detection of BPA and other phenolic compounds in real samples.