In this paper, we proposed and experimentally verified a diffraction-based optical beam shaping technique for underwater optical communication (UWOC) applications. The proposed method aimed to address the key issue in UWOC links, i.e., the high propagation loss experienced by the launched optical beam. It enabled a significantly higher portion of the launched signal to be collected by the receiver. The optimal transmission distance could also be fine-tuned by the software configuration. In a proof-of-concept demonstration based on the off-the-shelf components, 100 Mbps transmission was achieved over 15-meter distance and a significant enhancement in the transmission quality was observed. There is a huge scope for further improvement in the transmission distance and data rate when the proposed technique was used with purpose-built optical components and advanced coding schemes.

This paper demonstrates the design, assembly, optimisation and characterisation of 24 [1x12] wavelength selective switches (WSSs) based on a single set of optics and a 4k liquid crystal on silicon (LCoS) device. The average insertion loss was measured to be 8.4 dB with an average crosstalk level of 26.9 dB. To our knowledge, this module with 312 fibre ports is the highest-capacity WSS demonstrated so far. The module can be flexibly reconfigured into different switches and port counts for advanced reconfigurable optical add/drop multiplexer (ROADMs) applications.

Phase flickers in the digital liquid crystal on silicon (LCOS) devices employing the pulse width modulation (PWM) driving scheme have a detrimental effect on optical performances, especially in the non-display applications. This paper investigated the relationship between the PWM waveform and the corresponding phase flicker in digital LCOS devices. It has been identified that the magnitude of the phase flicker depends on the pulse patterns in the driving waveform as well as the dynamic response of the liquid crystal molecules at different tilting angles. A simple but generic method has been developed based on these findings, which is able to accurately predict the temporal phase response of the liquid crystal to any PWM waveforms. This method is further used for rapid identifications of low-flicker PWM waveforms, without the need for increasing the complexity of the driving circuitry. The peak-to-peak phase flicker in the LCOS device under our investigation has been reduced by >80% from ∼0.16pi to ∼0.03pi when operating at 30°C.

This paper demonstrates the design, assembly, optimisation and characterisation of a twin 1×35 wavelength selective switches (WSSs) based on a highly dispersive silicon grating prism (GRISM). The footprint of this WSS is reduced by >50% when compared with the standard module, without sacrificing key performance metrics including insertion loss, spectral coverage, passband, isolation, etc. To our knowledge, this module is the most compact high port count WSS demonstrated so far.