In order to determine the effect of the coupling region on train aerodynamic performance, and how the coupling region affects aerodynamic performance of the couple multiple units trains when they both run and pass each other in open air, the entrance of two such trains into a tunnel and their passing each other in the tunnel was simulated in Fluent 14.0. The numerical algorithm employed in this study was verified by the data of scaled and full-scale train tests, and the difference lies within an acceptable range. The results demonstrate that the distribution of aerodynamic forces on the train cars is altered by the coupling region; however, the coupling region has marginal effect on the drag and lateral force on the whole train under crosswind, and the lateral force on the train cars is more sensitive to couple multiple units compared to the other two force coefficients. It is also determined that the component of the coupling region increases the fluctuation of aerodynamic coefficients for each train car under crosswind. Affected by the coupling region, a positive pressure pulse was introduced in the alternating pressure produced by trains passing by each other in the open air, and the amplitude of the alternating pressure was decreased by the coupling region. The amplitude of the alternating pressure on the train or on the tunnel was significantly decreased by the coupling region of the train. This phenomenon did not alter the distribution law of pressure on the train and tunnel; moreover, the effect of the coupling region on trains passing by each other in the tunnel is stronger than that on a single train passing through the tunnel.
30 March 2017 in Proceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit
In this study, based on the shear-stress transport κ–ω turbulent model, the improved delayed detached eddy simulation method has been used to simulate the unsteady aerodynamic performance of trains with different obstacle deflectors at two yaw angles (0° and 15°). The numerical algorithm is used and some of the numerical results are verified through wind tunnel tests. By comparing and analysing the obtained results, the effects of the obstacle deflectors on the force of the trains as well as the pressure and flow structure around the trains are elucidated. The results show that the obstacle deflectors primarily affect the flow field at the bottom of the head car as well as the wake flow, and that the internal oblique-type obstacle deflector (IOOD) markedly improves the aerodynamic performance of the trains, by decreasing most of the aerodynamic forces of the train cars and minimising their fluctuations. Further, a nonzero yaw angle weakens or even changes the effect of the IOOD on the aerodynamic forces of the train cars. However, the effect of the IOOD is more on the tail car.
In this study, the spatial distribution of the transient pressure and the slipstream caused by a 1/10 scaled metro train passing through a tunnel was studied with moving model test. We hereby investigate the mechanism underlying the mitigation of the transient pressure on both the train surface and tunnel wall, as well as that of the slipstream in the tunnel. Experimental results showed that the airshaft at different locations in a tunnel had different pressure relief effects. The most significant pressure amplitude decreased by 36.0% with the airshaft locating in the middle of the tunnel. Meanwhile, the slipstream speed was also relieved from 0.45 to 0.36 after an airshaft. We also assessed and analyzed the impact of train speed on the transient pressures and slipstream. It was found that the increase of the train speed would increase the transient pressure and slipstream speed, but it did not effect their spatial distribution.
Transient numerical simulations were carried out by placing dimples at the top, sides and bottoms of the tail car streamline area of a high-speed maglev train. The results of an improved delayed detached eddy simulation turbulence model using three-dimensional compressible Navier-Stokes and shear-stress transport K-Omega double equations were compared to the results of a wind tunnel test to verify the numerical simulation accuracy, within 5% of the ground truth, which is an acceptable precision range. The results show that dimples arranged on the streamline area atop the train tail car affected the locations at which the airflow at the top and bottom of the train met and weakened the strength of the wake. The aerodynamic drag and lift coefficient decreased by 3.40% and 4.27%, respectively. When the dimples were arranged on the streamline area at the sides or bottoms of the train tail car, they had little effect on the top of the tail car, so they did not destroy the balance of the airflow at the top and bottom. They also had little influence on the development of wake topology. Therefore, the aerodynamic drag and lift of the train changed little.