This article presents a comprehensive, multidisciplinary overview of the development of powertrain technologies for energy-efficient heavy-duty earthmoving machines. The heavy-duty earthmoving equipment industry has been among the biggest contributors to emissions globally. However, due to high power demand and multidisciplinary powertrain structures, improving the energy efficiency of heavy-duty mobile machines has been a pressing and challenging task in the industry. To cope with this challenge, hydraulics and power electronics (PE) have been the key driving forces. As such, the relative developments in both fields are covered in this article. For hydraulics, developments of efficient hydraulic circuits will be overviewed in detail along with the introduction of hydraulic energy recovery technologies. In addition, developments of PE architectures in hybrid and electrified machines will be introduced. Furthermore, potential medium-voltage dc mining site power distribution and the valves of wide bandgap devices will also be discussed with the hope to open up new research opportunities in PE. Moreover, emerging hybrid electrohydraulic drive technology is introduced. Based on the overview in this article, it is anticipated that electrohydraulic hybridization will be the future trend in the earthmoving machine industry. Deeper collaboration between the two areas is desirable.

Fused deposition modeling (FDM) processed Poly-ether-ether-ketone (PEEK) materials are widely used in aerospace, automobile, biomedical, and electronics industries and other industries due to their excellent mechanical properties, thermal properties, chemical resistance, wear resistance, and biocompatibility, etc. However, the manufacture of PEEK materials and parts utilizing the FDM process faces the challenge of fine-tuning a list of process parameters and heat treatment conditions to reach the best-suiting mechanical properties and microstructures. It is non-trivial to make the selection only according to theoretical analysis while counting on a vast number of experiments is the general situation. Therefore, in this paper, the extrusion rate, filling angle, and printing orientation are investigated to adjust the mechanical properties of 3D-printed PEEK parts; then, a variety of heat treatment conditions were applied to tune the crystallinity and strength. The results show that the best mechanical performance is achieved at 1.0 times the extrusion rate, varied angle cross-fillings with ±10° intervals, and vertical printing. Horizontal printing performs better with reduced warpage. Additionally, both crystallinity and mechanical properties are significantly improved after heat treatment, and the best state is achieved after holding at 300 °C for 2 h. The resulting tensile strength is close to 80% of the strength of injection-molded PEEK parts.