The static and high frequency dielectric tensors, Born effective charges, vibrational spectrum at the Γ point, TO-LO splitting and IR intensities of calcite CaCO 3 have been calculated with the periodic ab initio CRYSTAL program, with five different basis sets of increasing size and four different Hamiltonians (HF, LDA, PBE, B3LYP). B3LYP is shown to perform better than the other options, in particular of LDA and PBE that are often used for the calculation of the vibrational spectrum of crystalline solids. When comparing B3LYP and experimental frequencies, the mean absolute difference is as small as 8.5 cm -1 ; this number reduces to 4.8 cm -1 if the two lowest experimental frequencies, that we suspect to be affected by a relatively large error, are excluded from statistics. Static and high frequency dielectric tensors, as well as IR intensities computed with the same hybrid scheme (B3LYP) compare quite favourably with experiment. The full set of modes is characterized by various tools including isotopic substitution, “freezing” one of the two subunits (Ca 2+ or CO 3 2- ) and graphical representations. A general tool has been implemented, that permits the automatic generation of the animation of the full set of modes starting from the CRYSTAL output (available at www.crystal.unito.it/vibs/calcite).

Mercury (Hg(II)) has been classified as a pollutant and its removal from aqueous sources is considered a priority for public health as well as ecosystem protection policies. Oxidized graphenes have attracted vast interest in water purification and wastewater treatment. In this report, a partially reduced graphene oxide is proposed as a pristine adsorbent material for Hg(II) removal. The proposed material exhibits a high saturation Hg(II) uptake capacity of 110.21 mg g⁻¹, and can effectively reduce the Hg(II) concentration from 150 mg L⁻¹ to concentrations smaller than 40 mg L⁻¹, with an efficiency of about 75% within 20 min. The adsorption of Hg(II) on reduced graphene oxide shows a mixed physisorption–chemisorption process. Density functional theory calculations confirm that Hg atom adsorbs preferentially on clean zones rather than locations containing oxygen functional groups. The present work, therefore, presents new findings for Hg(II) adsorbent materials based on partially reduced graphene oxide, providing a new perspective for removing Hg(II).