When applied to a snow-covered surface, aerodynamic roughness length, z0, is typically considered as a static parameter within energy balance equations. However, field observations show that z0 changes spatially and temporally, and thus z0 incorporated as a dynamic parameter may greatly improve models. To evaluate methods for characterizing snow surface roughness, we compared concurrent estimates of z0 based on (1) terrestrial light detection and ranging derived surface geometry of the snowpack surface (geometric, z0G) and (2) vertical wind profile measurements (anemometric, z0A). The value of z0G was computed from Lettau’s equation and underestimated z0A but compared well when scaled by a factor of 2.34. The Counihan method for computing z0G was found to be unsuitable for estimating z0 on a snow surface. During snowpack accumulation in early winter, z0 varied as a function of the snow-covered area (SCA). Our results show that as the SCA increases, z0 decreases, indicating there is a topographic influence on this relation.
1 November 2008 in European Journal of Mechanics - B/Fluids
The roughness of the Earth’s surface dictates the nature of air flow across it. Detailed meteorological data that are necessary to access the aerodynamic roughness () are not widely collected and, as such, the geometry of a surface can be used to estimate . Here, we present a novel formulation, and the corresponding computer code, to compute based on the Lettau (1969) geometric approach. The new code produces a mean , as well as a histogram of all values for each individual roughness element (e.g., 10 s of thousand for the 1000 × 1000 grids) discretized using watersheds, as well as directional diagrams, which can be matches with the wind rose for the location. The formulation includes two parameters that may optionally be applied to smooth the surface before calculating . By calculating as a function of these two parameters, we demonstrate the sensitivity of the value to these parameter choices. Since a large portion of the Earth’s surface is snow covered during some parts of the year, and the roughness of the snow surface varies over the snow season and over space, we apply the code to three snow surface datasets. Each surface is during a different phases of the snowpack. Each surface is evaluated at two resolutions). These surfaces are: fresh snow accumulation (1 m2 at 1 and 10 mm), peak accumulation (1 km2 at 1 and 10 m) and ablation sun cups (25 m2 at 5 and 50 mm).
We report on a new mode interaction found in electroconvection experiments on the nematic liquid crystal mixture Phase V in planar geometry. The mode interaction (codimension two) point occurs at a critical value of the frequency of the driving AC voltage. For frequencies below this value the primary pattern-forming instability at the onset voltage is an oblique stationary instability involving oblique rolls, and above this value it is an oscillatory instability giving rise to normal traveling rolls (oriented perpendicular to and traveling in the director direction). The transition has been confirmed by measuring the roll angle and the dominant frequency of the time series, as both quantities exhibit a discontinuous jump across zero when the AC frequency is varied near threshold. The globally coupled system of Ginzburg–Landau equations that qualitatively describe this mode interaction is constructed, and the resulting normal form, in which slow spatial variations of the mode amplitudes are ignored, is analyzed. This analysis shows that the Ginzburg–Landau system provides the adequate theoretical description for the experimentally observed phenomenon. The experimentally observed patterns at and higher above the onset allow us to narrow down the range of the parameters in the normal form.