Protective coatings have received considerable attention for the surface treatment of devices. Herein, in situ grown nanoparticles, TiO2 on Ti3C2Tx sheets (TiO2/Ti3C2Tx), are prepared by a simple hydrothermal oxidation method possessing the layer structure, which is applied to prepare protective coatings. The Ni–P–TiO2/Ti3C2Tx coating is prepared by electroplating technology, revealing more excellent properties than those of the Ni–P coating. Compared with the Ni–P coating, even though the Ni–P–TiO2/Ti3C2Tx coating holds the rough surface, the wettability is changed from hydrophilic to hydrophobic, owing to the gathering existence of TiO2/Ti3C2Tx on the surface and coarse surface texture. In addition, the participation of TiO2/Ti3C2Tx in the Ni–P coating can improve the capacity of corrosion prevention and decrease the corrosion rate. According to the results of hardness and wear tests, microhardness of the Ni–P–TiO2/Ti3C2Tx coating is approximately 1350 kg mm−2 and the coefficient of friction (COF) of Ni–P–TiO2/Ti3C2Tx coatings is about 0.40, which is much lower than that of Ni–P coatings. Thus, the Ni–P–TiO2/Ti3C2Tx coating can be a promising material to protect the surface of equipment.
The rapid clustering of Chemical Industrial Parks (CIPs) has escalated the risk of cascading disasters (e.g., toxic leaks and explosions), underscoring the need for resilient emergency logistics systems. However, traditional two-stage optimization models often yield suboptimal outcomes due to decoupled facility location and routing decisions. To address this issue, we propose a unified mixed-integer nonlinear programming (MINLP) model that integrates site selection and routing decisions in a single framework. The model accounts for multi-source supply allocation, enforces minimum safety distance constraints, and incorporates heterogeneous economic factors (e.g., regional land costs) to ensure risk-aware, cost-efficient planning. Two deployment scenarios are considered: (1) incremental augmentation of an existing emergency network and (2) full network reconstruction after a systemic failure. Simulations on a regional CIP cluster (2400 × 2400 km) were conducted to validate the model. The integrated approach reduced facility and operational costs by 9.77% (USD 13.68 million saved) in the incremental scenario and achieved a 15.10% (USD 21.13 million saved) total cost reduction over decoupled planning in the reconstruction scenario while maintaining an 8 km minimum safety distance. This integrated approach can enhance cost-effectiveness and strengthen the resilience of high-risk industrial emergency response networks. Overall, the proposed modeling framework, which integrates spatial constraints, time-sensitive supply mechanisms, and disruption risk considerations, is not only tailored for hazardous chemical zones but also exhibits strong potential for adaptation to a variety of high-risk scenarios, such as natural disasters, industrial accidents, or critical infrastructure failures.