Until now, most studies using calcium alginate gel (CAG) have been conducted primarily at room temperature (20 °C) without considering gelation temperature. Moreover, the effects of gelation temperature on the physical properties of CAG beads have not been studied in detail. We aimed to study the effect of gelation temperature on the physical properties (diameter, sphericity, and rupture strength) of CAG beads. Response surface methodology was used in this study. The independent variables were sodium alginate concentration (X₁, 1.2–3.6%, w/v), calcium lactate concentration (X₂, 0.5−4.5%, w/v), gelation temperature (X₃, 5–85 °C), and gelation time (X₄, 6–30 min). Diameter (Y₁, mm), sphericity (Y₂, %), and rupture strength (Y₃, kPa) were selected as the dependent variables. A decrease in gelation temperature increased the diameter, sphericity and rupture strength of the CAG beads. Additionally, the CAG beads prepared at 5 °C exhibited the highest rupture strength (3976 kPa), lowest calcium content (1.670 mg/g wet), and a regular internal structure. These results indicate that decreasing the gelation temperature slows the calcium diffusion rate in CAG beads, yielding a more regular internal structure and increasing the rupture strength of the beads.

Calcium alginate gel (CAG) has been widely investigated for the development of artificial foods; however, there are few studies on its thermal stability. This study aimed to monitor changes in the physical properties of CAG beads during heat treatment using response surface methodology. Heating temperature (X₁, 40–100 °C) and heating time (X₂, 5–60 min) were chosen as independent variables. The dependent variables were rupture strength (Y₁, kPa), size (Y₂, μm), and sphericity (Y₃, %). The heating temperature (X₁) was the independent variable that had a significant effect on the rupture strength (Y₁) and size (Y₂). Rupture strength (Y₁) increased as the heating temperature (X₁) increased; at the same time, the CAG beads size (Y₂) decreased. With all conditions, the values of sphericity (Y₃) were over 94%. SEM images revealed that increase in the rupture strength of the CAG beads by heat treatment resulted from their porous structures. Loss of moisture by syneresis, occurring with heat treatment, was judged to create a dense porous structure of CAG beads. Our findings offer useful information for cooking or sterilizing food products utilizing CAG beads. In addition, thermal treatment could be applied to produce hard CAG beads with a high rupture strength.

In our previous studies, a standardized phlorotannin (brown seaweed polyphenol) supplement (PS) exhibited sleep-promoting effects via type A γ-aminobutyric acid-benzodiazepine receptors in mice. In addition, in human clinical trials, it decreased wake after sleep onset in adults with sleep disturbance. In this follow-up study, we investigated whether PS attenuates caffeine-induced sleep disruption in mice. The effects of PS were evaluated in a caffeine model by analyzing sleep architecture based on electroencephalogram and electromyogram findings, and were compared with the effects of a well-known sedative-hypnotic drug zolpidem (ZPD). As expected, oral administration of caffeine (25 mg/kg) significantly increased sleep latency and decreased the amount of non-rapid eye movement sleep (NREMS). In the caffeine + PS and caffeine + ZPD groups, PS (500 mg/kg) attenuated caffeine-induced sleep disruption, and its effects were comparable with those of ZPD (10 mg/kg). In particular, PS inhibited the arousal effects of caffeine without change in delta activity during NREMS, whereas ZPD produced a decrease in the delta activity. Considering global trends in coffee and energy drink consumption, our finding suggest that PS may be useful to relieve transitory insomnia symptoms caused by caffeine consumption, unlike the prescription drug ZPD.