The efficacy of dual-polarization radar for quantitative precipitation estimation (QPE) has been demonstrated in a number of previous studies. Specifically, rainfall retrievals using combinations of reflectivity (Zh), differential reflectivity (Zdr), and specific differential phase (Kdp) have advantages over traditional Z–R methods because more information about the drop size distribution (DSD) and hydrometeor type are available. In addition, dual-polarization-based rain-rate estimators can better account for the presence of ice in the sampling volume. An important issue in dual-polarization rainfall estimation is determining which method to employ for a given set of polarimetric observables. For example, under what circumstances does differential phase information provide superior rain estimates relative to methods using reflectivity and differential reflectivity? At Colorado State University (CSU), an optimization algorithm has been developed and used for a number of years to estimate rainfall based on thresholds of Zh, Zdr, and Kdp. Although the algorithm has demonstrated robust performance in both tropical and midlatitude environments, results have shown that the retrieval is sensitive to the selection of the fixed thresholds. In this study, a new rainfall algorithm is developed using hydrometeor identification (HID) to guide the choice of the particular rainfall estimation algorithm. A separate HID algorithm has been developed primarily to guide the rainfall application with the hydrometeor classes, namely, all rain, mixed precipitation, and all ice. Both the data collected from the S-band Colorado State University–University of Chicago–Illinois State Water Survey (CSU–CHILL) radar and a network of rain gauges are used to evaluate the performance of the new algorithm in mixed rain and hail in Colorado. The evaluation is also performed using an algorithm similar to the one developed for the Joint Polarization Experiment (JPOLE). Results show that the new CSU HID-based algorithm provides good performance for the Colorado case studies presented here.
1 September 2013 in Journal of Applied Meteorology and Climatology
A new 10-category, polarimetric-based hydrometeor identification algorithm (HID) for C band is developed from theoretical scattering simulations including wet snow, hail, and big drops/melting hail. The HID is applied to data from seven wet seasons in Darwin, Australia, using the polarimetric C-band (C-POL) radar, to investigate microphysical differences between monsoon and break periods. Scattering simulations reveal significant Mie effects with large hail (diameter > 1.5 cm), with reduced reflectivity and enhanced differential reflectivity Zdr and specific differential phase Kdp relative to those associated with S band. Wet snow is found to be associated with greatly depreciated correlation coefficient ρhv and moderate values of Zdr. It is noted that large oblate liquid drops can produce the same electromagnetic signatures at C band as melting hail falling quasi stably, resulting in some ambiguity in the HID retrievals. Application of the new HID to seven seasons of C-POL data reveals that hail and big drops/melting hail occur much more frequently during break periods than during monsoon periods. Break periods have a high frequency of vertically aligned ice above 12 km, suggesting the presence of strong electric fields. Reflectivity and mean drop diameter D0 statistics demonstrate that convective areas in both monsoon and break periods may have robust coalescence or melting precipitation ice processes, leading to enhanced reflectivity and broader distributions of D0. Conversely, for stratiform regions in both regimes, mean reflectivity decreases below the melting level, indicative of evaporative processes. Break periods also have larger ice water path fractions, indicating substantial mixed-phase precipitation generation as compared with monsoonal periods. In monsoon periods, a larger percentage of precipitation is produced through warm-rain processes.
In this article a potential role of snowflake growth by aggregation on formation of dual‐polarization radar signatures in winter storms is discussed. We advocate that the observed bands of increased values of specific differential phase (Kdp) can be linked to the onset of aggregation. These bands are caused by high number concentrations of oblate relatively dense ice particles and take place in regions where an ice phase “seeder‐feeder” is active. On the other hand, the differential reflectivity (Zdr) bands, in absence of detectable Kdp values, are observed in the areas where crystal growth is the dominating snow growth mechanism and ice particle number concentration is lower. This distinction in underlying processes explains why Kdp and Zdr bands are not always observed at the same time. Furthermore, based on surface observations of snowflakes, it is determined that early aggregates, consisting of a small number of ice crystals, are oblate. These oblate particles could contribute to the reported dual‐polarization radar signatures in snow, especially to the Kdp. This could help to explain why, where observed at the same type, Kdp and Zdr bands do not match and the altitude of the peak value of Kdp is usually lower than the Zdr one. It also means that dual‐polarization radar signatures of snowflakes may depend on a stage of aggregation.
Planetary boundary layer (PBL) height plays a significant role in climate modeling, weather forecasting, air quality prediction, and pollution transport processes. This study examined the climatology of PBL-associated meteorological parameters over the Korean peninsula and surrounding sea using data from the ERA5 dataset produced by the European Centre for Medium-range Weather Forecasts (ECMWF). The data covered the period from 2008 to 2017. The bulk Richardson number methodology was used to determine the PBL height (PBLH). The PBLH obtained from the ERA5 data agreed well with that derived from sounding and Global Positioning System Radio Occultation datasets. Significant diurnal and seasonal variability in PBLH was observed. The PBLH increases from morning to late afternoon, decreases in the evening, and is lowest at night. It is high in the summer, lower in spring and autumn, and lowest in winter. The variability of the PBLH with respect to temperature, relative humidity, surface pressure, wind speed, lower tropospheric stability, soil moisture, and surface fluxes was also examined. The growth of the PBLH was high in the spring and in southern regions due to the low soil moisture content of the surface. A high PBLH pattern is evident in high-elevation regions. Increasing trends of the surface temperature and accordingly PBLH were observed from 2008 to 2017.
Air pollution is a serious challenge in South Korea and worldwide, and negatively impacts human health and mortality rates. To assess air quality and the spatiotemporal characteristics of atmospheric particulate matter (PM), PM concentrations were compared with meteorological conditions and the concentrations of other airborne pollutants over South Korea from 2015 to 2020, using different linear and non-linear models such as linear regression, generalized additive, and multivariable linear regression models. The results showed that meteorological conditions played a significant role in the formation, transportation, and deposition of air pollutants. PM2.5 levels peaked in January, while PM10 levels peaked in April. Both were at their lowest levels in July. Further, PM2.5 was the highest during winter, followed by spring, autumn, and summer, whereas PM10 was the highest in spring followed by winter, autumn, and summer. PM concentrations were negatively correlated with temperature, relative humidity, and precipitation. Wind speed had an inverse relationship with air quality; zonal and vertical wind components were positively and negatively correlated with PM, respectively. Furthermore, CO, black carbon, SO2, and SO4 had a positive relationship with PM. The impact of transboundary air pollution on PM concentration in South Korea was also elucidated using air mass trajectories.