This paper systematically investigates the dynamic behavior of stay cables with passive negative stiffness dampers (NSD) installed close to the cable end. A passive NSD is modeled as a combination of a negative stiffness spring and a viscous damper. Through both analytical and numerical approaches, parametric analysis of negative stiffness and viscous damping are conducted to systematically evaluate the vibration control performance of passive NSD on stay cables. Since negative stiffness is an unstable element, the boundary of passive negative stiffness for stay cables to maintain stability is also derived. Results reveal that the asymptotic approach is only applicable to passive dampers with positive or moderate negative stiffness, and loses its accuracy when a passive NSD possesses significant negative stiffness. It has been found that the performance of passive NSD can be much better than those of conventional viscous dampers. The superior control performance of passive NSD in cable vibration mitigation is validated through numerical simulations of a full-scale stay cable.
Stay cables are vulnerable to excessive vibration because of their inherently low damping properties. Described in this paper is an experimental investigation of the vibration control performance due to passive negative stiffness dampers (NSDs) installed on a scaled stay cable model. The passive NSD used in the experiment was composed of a viscous damper and a magnetic negative stiffness spring with an adjustable stiffness coefficient installed close to one cable end in the transverse direction. In general, the passive NSD performed much more effectively than conventional viscous dampers in mitigating the vibration of the stay cable. As the negative stiffness strength increased, the cable responses under various dynamic loadings became smaller, thus indicating that high damping had been added to the stay cable. A damping ratio higher than 10% was obtained in the cable vibration tests. The flexural rigidity of the stay cable is a parameter often overlooked. However, after the installation of a passive NSD, this was found to be of importance. The actual influence of flexural rigidity depends on the negative stiffness coefficient, the damper location, and the boundary condition of the stay cable. Numerical simulation results taking account of the flexural rigidity and boundary conditions agreed well with the experimental results.
The installation of dampers close to cable anchorages is a common approach for stay-cable vibration mitigation. Inspired by the force-deformation relationship produced by actively controlled dampers, passive negative-stiffness dampers (NSDs) were proposed for stay cables in the past to achieve excellent vibration-control performance. However, a systematic comparison between passive NSDs and active control in cable vibration mitigation has rarely been reported in literature. This paper systematically compares vibration mitigation performances of a passive NSD to the performance of two active control methods, linear quadratic regulator (LQR) and output feedback control. The comparison indicates that a passive NSD can offer a stay cable with a high damping level comparable to that of LQR control. However, passive NSD will also decrease the modal frequencies of a stay cable, whereas LQR will increase the frequencies slightly. The dynamic response results also indicate that the active LQR control offers slightly better control performance than the passive NSD in various loading cases. The superiority of the LQR control over the passive NSD can be explained through an output feedback control approach. It is noteworthy that the NSD is regarded as more practical and reliable because it offers protection by completely passive means without the need for the feedback and actuation that are required in active control.