In today’s contemporary civilization, there is a growing need for clean energy focused on preserving the environment; thus, dielectric capacitors are crucial equipment in energy conversion. On the other hand, the energy storage performance of commercial BOPP (Biaxially Oriented Polypropylene) dielectric capacitors is relatively poor; hence, enhancing their performance has drawn the attention of an increasing number of researchers. This study used heat treatment to boost the performance of the composite made from PMAA and PVDF, combined in various ratios with good compatibility. The impacts of varying percentages of PMMA-doped PMMA/PVDF mixes and heat treatment at varying temperatures were systematically explored for their influence on the attributes of the blends. After some time, the blended composite’s breakdown strength improves from 389 kV/mm to 729.42 kV/mm at a processing temperature of 120 °C. Consequently, the energy storage density is 21.12 J/cm³, and the discharge efficiency is 64.8%. The performance has been significantly enhanced compared to PVDF in its purest state. This work offers a helpful technique for designing polymers that perform well as energy storage materials.

It has been proved that surface integrity alteration induced by machining process has a profound influence on the performance of a component. As a widely used processing technology, milling technology can process parts of different quality grades according to the processing conditions. The different cutting conditions will directly affect the surface state of the machined parts (surface texture, surface morphology, surface residual stress, etc.) and affect the final performance of the workpiece. Therefore, it is of great significance to reveal the mapping relationship between working conditions, surface integrity, and parts performance in milling process for the rational selection of cutting conditions. The effects of cutting parameters such as cutting speed, feed speed, cutting depth, and tool wear on the machined surface integrity during milling are emphatically reviewed. At the same time, the relationship between the machined surface integrity and the performance of parts is also revealed. Furthermore, problems that exist in the study of surface integrity and workpiece performance in milling process are pointed out and we also suggest that more research should be conducted in this area in future.