We report the study of two-dimensional graphitic carbon nitride (GCN) functionalized with copper single atoms as a catalyst for the reduction of CO₂ (CO2RR). The correct GCN structure, as well as the adsorption sites and the coordination of the Cu atoms, was carefully determined by combining experimental techniques, such as X-ray diffraction, transmission electron microscopy, X-ray absorption, and X-ray photoemission spectroscopy, with DFT theoretical calculations. The CO2RR products in KHCO₃ and phosphate buffer solutions were determined by rotating ring disk electrode measurements and confirmed by ¹H-NMR and gas chromatography. Formate was the only liquid product obtained in bicarbonate solution, whereas only hydrogen was obtained in phosphate solution. Finally, we demonstrated that GCN is a promising substrate able to stabilize metal atoms, since the characterization of the Cu-GCN system after the electrochemical work did not show the aggregation of the copper atoms.

Carbon dioxide reduction into useful chemical products is a key technology to address urgent climate and energy challenges. In this study, a nanohybrid made by Co₃O₄ and graphene is proposed as an efficient electrocatalyst for the selective reduction of CO₂ to formate at low overpotential. The comparison between samples with different metal oxide to carbon ratio and with or without doping of the graphene moiety, indicates that the most active catalyst is formed by highly dispersed and crystalline nanocubes exposing {001} oriented surfaces, whereas the nitrogen doping is critical to obtain a controlled morphology and to facilitate a topotactic transformation during electrocatalytic conditions to CoO, which results to be the true active phase. The nanohybrid made up by intermediate loading of Co₃O₄ supported on Nitrogen doped graphene is the most active catalyst, being able to produce 3.14 mmol of formate in 8 h at -0.95 V vs SCE with a faradic efficiency of 83%.

Carbon nanomaterials are promising adsorbents for dye removal from wastewater also due to their possible surface functionalization that, in principle, can increase the adsorption rate and provide regeneration. To investigate the real advantages of functionalization, we synthesized and characterized through IR, TGA, TEM, XPS and DLS measurements a multi-walled carbon nanotube (MWCNT) derivative bearing benzenesulfonate groups (MWCNT-S). The obtained material demonstrated to have good dispersibility in water and better capability to adsorb methylene blue (MB) compared to the pristine MWCNT adsorbent. Adsorption kinetic studies showed a very fast process, with a constant significantly higher with respect not only to that of the unfunctionalized MWCNT adsorbent but also to those of widely used activated carbons. Moreover, the adsorption capacity of MWCNT-S is more than doubled with respect to that of the insoluble pristine MWCNT adsorbent, thanks to the dispersibility of the derivatives, providing a larger available surface, and to the possible electrostatic interactions between the cationic MB and the anionic sulfonate groups. Additionally, the reversibility of ionic interactions disclosed the possibility to release the adsorbed cationic pollutant through competition with salts, not only regenerating the adsorbent, but also recovering the dye. Indeed, by treating the adsorbed material for 1 h with 1 M NaCl, a regeneration capacity of 75% was obtained, demonstrating the validity of this strategy.

We have investigated three-dimensional (3D) MoS₂ nanoarchitectures doped with different amount of Ni to boost the hydrogen evolution reaction (HER) in alkaline environment, where this reaction is normally hindered. As a comparison, the activity in acidic media was also investigated to determine and compare the role of the Ni sites in both media. The doping of MoS₂, especially at high loadings, can modify its structural and/or electronic properties, which can also affect the HER activity. The structural and electronic properties of the Ni doped 3D-MoS₂ nanoarchitecture were studied by X-ray diffraction (XRD), Raman spectroscopy, scanning and transmission electronic microscopy (SEM; TEM), and X-ray photoemission Spectroscopy (XPS). XPS also allowed us to determine the Ni-based species formed as a function of the dopant loading. The HER activity of the materials was investigated by linear sweep voltammetry (LSV) in 0.5 M H₂SO₄ and 1.0 M KOH. By combining the physicochemical and electrochemical results, we concluded that the Ni sites have a different role in the HER mechanism and kinetics in acidic and in alkaline media. Thus, NiS_x species are essential to promote HER in alkaline medium, whereas the Ni-Mo-S ones enhance the HER in acid medium.