This paper presents the realization of a flexible thermoelectric (TE) generator as a textile fabric that converts human body heat into electrical energy for portable, low-power microelectronic products. In this study, an organic non-toxic conductive coating was used to dip rayon wipes into conductive TE fabrics so that the textile took advantage of the TE currents which were parallel to the temperature gradient. To this end, a dyed conductive cloth was first sewn into a TE unit. The TE unit was then sewn into an array to create a temperature difference between the human body and the environment for TE power harvesting. The prototype of the TE fabric consisted of 48 TE units connected by conductive wire over an area of 275 × 205 mm2, and the TE units were sewn on a T-shirt at the chest area. After fabrication and property tests, a Seebeck coefficient of approximately 20 μV/K was measured from the TE unit, and 0.979 mV voltage was obtained from the T-shirt with TE textile fabric. Since the voltage was generated at a low temperature gradient environment, the proposed energy solution in actual fabric applications is suitable for future portable microelectronic power devices.
1 September 2013 in International Journal of Electronics
Through-silicon via (TSV) is one of the key technologies on three-dimensional integration packaging. In this article, an experimental methodology with circuit models was proposed for electrical characteristic tests on typical TSV structures. To this end, self-developed test patterns such as the via chains, the snake interconnections and the Kelvin structures with different dimensions were designed and manufactured. Suitable electrical measurement methodologies were next employed to characterise the element behaviours of the patterns. Based on the experimental data, electrical circuit models for the TSV structures were introduced and the parameters of the model were exacted. The validity and accuracy of the electrical model were finally verified and the TSV characteristic measurements can be performed through a simpler process.
Due to the carrier mobility changes with the mechanical loading and its small size, the MOSFET (metal-oxide-semiconductor field-effective-transistor) has the potential to be a suitable chip stress monitoring tool for microelectronic packaging. In this work, a complete and accurate approach to calibrate the coefficients for both types of MOSFET stress sensors under thermal and mechanical loadings was investigated quantitatively. Through data from different measurement modes on different types of MOSFET, the optimal experimental methodology was next proposed for the sensor applications on packaging stress extraction. The thermomechanical coupling coefficients for the selected experimental mode were finally extracted so that packaging stress measurements with MOSFET under elevated temperature can be performed more accurately.
Three-dimensional (3D) structure with through silicon via (TSV) technology is emerging as a key issue in microelectronic packaging industry, and electrical reliability has become one of the main technical subjects for the TSV designs. However, criteria used for TSV reliability tests have not been consistent in the literature, so that the criterion itself becomes a technical argument. To this end, this paper first performed several different reliability tests on the testing packaging with TSV chains, then statistically analyzed the experimental data with different failure criteria on resistance increasing, and finally constructed the Weibull failure curves with parameter extractions. After comparing the results, it is suggested that using different criteria may lead to the same failure mode on Weibull analyses, and 65% of failed devices are recommended as a suitable termination for reliability tests.
27 December 2018 in IEEE Transactions on Components, Packaging and Manufacturing Technology
The parasitic effect inside through silicon via (TSV) packaging under radio-frequency (RF) operation may cause abnormal signals in circuit performance. On the bases of a self-developed de-embedding technique, we investigated the high frequency characteristics of a typical TSV structure through direct measurements. To this end, a silicon substrate layout was first designed and constructed, followed by packaging mounting to build a suitable setting for RF measurements. Behaviors up to 3 GHz on different circuit segments in an actual TSV packaging were then measured directly by using an RF-LCR (inductance, capacitance, and resistance) meter, and R, L, and impedance (Z) data for test structures were then extracted and compared with those reported in the literature. To study the environmental effect on the RF properties of the TSV test samples, we monitored behaviors during a temperature-humidity reliability test.