For operating at the CO2 laser wavelength (10.6 μm), we manufactured single- and double-layered infrared (IR) fibers, as well as those with an enlarged mode field diameter, obtained via extrusion from Ag(Cl)xBr1 − x (0 < x < 1), Ag1 − xTlxBr1 − xIx (0 < x ≤ 0.08), Ag1 − xTlxClyIzBr1 − y − z (0.003 ≤ x ≤ 0.040; 0.066 ≤ y ≤ 0.246; 0.004 ≤ z ≤ 0.048) crystals. We calculated their fundamental characteristics at 10.6 μm and conducted computer simulation of their structure and mode field beforehand. Optical and mechanical characteristics of IR crystals and fibers, such as transmission range, refractive indices, and durability, were also determined, with the dependence of varying monadic thallium iodide content on them being shown as well. In particular, we demonstrated that the increase of thallium iodide content in the initial silver chloride bromide widens the transparency range to 40 μm and improves the rupture strength up to 200 MPa, which is due to the decrease in average fiber grain size up to 95 nm—nanocrystalline size. Using a CCD camera for the far field investigation at 10.6 μm, we showed the single mode of the fibers obtained.
22 July 2020 in Journal of Thermal Analysis and Calorimetry
Broadband mid-infrared (B-MIR) thermography using fibre optic waveguides can be critical in real-time imaging in harsh environments such as additive manufacturing, personalised medical diagnosis and therapy. We investigate the polarisation effect on thermal measurements through poly-crystalline fibre bundle employing a simple broadband cross-polarisation configuration experimental set-up. Silver halide poly-crystalline fibres AgCl1−xBrx (0 ≤ x≤1) (AgClBr-PolyC) have very wide transmission bandwidth spanning over the spectral range from 1 µm up to 31 µm FWHM. Moreover, they are non-toxic, non-hygroscopic, with relatively good flexibility, which make them very adequate for spectroscopic and thermal measurements in medical and clinical fields. In this study, we used a fibre bundle composed of seven single AgClBr-PolyC fibres, each with a core diameter of about 300 µm, inserted between two broadband MIR polarisers. A silicon carbide filament source was placed at the entrance of the fibre bundle, while a FLIR thermal camera with a close-up lens was employed to measure the spatial temperature distribution over the fibre-bundle end. Indeed, polarisation dependence of temperature measurements has been clearly observed in which the orientation of temperature extrema (minima and maxima) vary from one fibre to another within the bundle. Moreover, these observations have enabled the classification of AgClBr-PolyC fibres following their polarisation sensitivities by which some fibres are relatively highly sensitive to polarisation with polarisation temperature difference (PTD) that can reach 22.1 ± 2.8 °C, whereas some others show very low PTD values down to 3.1 ± 2.8 °C. Many applications can readily be found based on the advantages of both extreme cases.