Paper-based surface-enhanced Raman scattering (SERS) sensors have garnered much attention in the past decade owing to their ubiquity, ease of fabrication, and environmentally friendly substrate. The main drawbacks of a paper substrate for a SERS sensor are its high porosity, inherent hygroscopic nature, and hydrophilic surface property, which reduce the sensitivity and reproducibility of the SERS sensor. Here, we propose a simple, quick, convenient, and economical method for hydrophilic to hydrophobic surface modification of paper, while enhancing its mechanical and moisture-resistant properties. The hydrophobic paper (h-paper) was obtained by spin-coating diluted polydimethylsiloxane (PDMS) solution onto the filter paper, resulting in h-paper with an increased contact angle of up to ≈130°. To complete the h-paper-based SERS substrate, gold nanoparticles arranged on graphene oxide (AuNPs@GO) were synthesized using UV photoreduction, followed by drop-casting of AuNPs@GO solution on the h-paper substrate. The enhancement of the SERS signal was then assessed by attaching a rhodamine 6G (R6G) molecule as a Raman probe material to the h-paper-based SERS substrate. The limit of detection was 10 nM with an R2 of 0.966. The presented SERS sensor was also tested to detect a thiram at the micromolar level. We expect that our proposed AuNPs@GO/h-paper-based SERS sensor could be applied to point-of-care diagnostics applications in daily life and in spacecraft.
Paper-based strain sensors have attracted attention as a cost-effective and environmentally friendly approach to wearable electronic devices. This study proposes a paper-based strain sensor created solely using hand-painting, which is a simple, equipment-free process utilized in green electronics. Commercial printing paper is coated with polydimethylsiloxane diluted with heptane, which provides moisture resistance and mechanical robustness while increasing the hydrophobicity of the surface. The electrodes and conduction channels are fabricated using a pencil for graphite deposition and a brush for the deposition of tin-doped indium oxide nanoparticles, respectively. With a gauge factor of 41.98 in tensile strain tests and 21.36 in compressive strain tests, our strain sensor exhibits a good sensitivity that is similar to that of previously reported paper-based sensors. We also demonstrate that our proposed strain sensor can be used as a weak motion detection device for humans and robots.
We propose a tiny surface plasmon resonance (SPR) sensor integrated on a silicon waveguide based on vertical coupling into a finite thickness metal-insulator-metal (f-MIM) plasmonic waveguide structure acting as a Fabry-Perot resonator. The resonant characteristics of vertically coupled f-MIM plasmonic waveguides are theoretically investigated and optimized. Numerical results show that the SPR sensor with a footprint of ~0.0375 μm2 and a sensitivity of ~635 nm/RIU can be designed at a 1.55 μm transmission wavelength.
1 September 2015 in Sensors and Actuators B: Chemical