The use of Computational Fluid Dynamics (CFD) to assist in air quality studies in urban environments can provide accurate results for the dispersion of pollutants. However, due to the computational resources needed, simulation domain sizes tend to be limited. This study aims to improve the computational efficiency of an emission and dispersion model implemented in a CPU-based solver by migrating it to a CPU–GPU-based one. The migration of the functions that handle boundary conditions and source terms for the pollutants is explained, as well as the main differences present in the solvers used. Once implemented, the model was used to run simulations with both engines on different platforms, enabling the comparison between them and reaching promising time improvements in favor of the use of GPUs.

The Hydrostatic Pressure Machine (HPM) is a novel energy converter for micro and pico hydropower that becomes very suitable for installation in channels with very low head, where conventional hydraulic turbines are inadequate or too expensive. Although this technology has been studied through several experimental tests and also by numerical simulations, open source flow solvers have not been used yet. The research team on Computational Fluid Mechanics of IMFIA- Universidad de la República (Uruguay) has been developing a CFD open source solver named caffa3d, which has obtained great results in a few international challenges, although it has not been used yet for free surface flows or turbomachinery simulations. The present work shows the contributions made within caffa3d in order to enable its use for simulating a HPM. The Large Eddy Simulation (LES) method is used to model the turbulence structures of the flow. Sliding Mesh (SM) and Volume of Fluid (VOF) methods were chosen respectively to resolve the rotation of the wheel and the position of the free surface. The SM module was already validated in the past, but the VOF module needed to be validated in the present work through the simulation of free surface over a semicylindrical dam. Finally, the performance of a small 12-straight-blade HPM was simulated with caffa3d, with quite satisfactory results. Some issues of the solver yet need to be solved before other HPM with more complex designs could be studied.

Recently, the Actuator Line Model (ALM) has been evaluated with coarser resolution and larger time steps than what is generally recommended, taking into account an atmospheric sheared and turbulent inflow condition. The aim of the present paper is to continue these studies, assessing the capability of the ALM to represent the wind turbines' interactions in an onshore wind farm. The 'Libertad' wind farm, which consists of four 1.9MW Vestas V100 wind turbines, was simulated considering different wind directions, and the results were compared with the wind farm SCADA data, finding good agreement between them. A sensitivity analysis was performed to evaluate the influence of the spatial resolution, finding acceptable agreement, although some differences were found. It is believed that these differences are due to the characteristics of the different Atmospheric Boundary Layer (ABL) simulations taken as inflow condition (precursor simulations).