In recent years, the exploitation and utilization of offshore oil and gas resources have attracted more attention. In offshore gas reservoir production, wellbore temperature and pressure change continuously when water-bearing natural gas flows upward. The wellbore temperature is also affected by the low-temperature sea water. The combination of temperatures and pressures controlled by the upward flow, and cooling from the surrounding seawater frequently leads to the conditions of temperature and pressure for hydrate formation. This can lead to pipeline blockage and other safety accidents. In this study, we utilize mathematical models of hydrate phase equilibrium, wellbore temperature, wellbore pressure to study hydrate formation and decomposition in offshore gas reservoir production. Numerical solution algorithms are developed and numerical solutions are validated. The sensitivity influence of different parameters on the regions and regularities of hydrate formation and decomposition in wellbores are obtained through numerical simulations. It is found that increased daily gas production, water content, or geothermal gradient in offshore gas reservoir production pipelines results in less hydrate formation in the wellbores. Accordingly, the risk of wellbore blockage decreases and production safety is maintained. Decreased tubing head pressure or seawater depth results in similar effects. The result of this study establishes a set of prediction methods for hydrate formation and decomposition that can be used in the development of guidelines for safe construction design.

During the trial production of marine gas hydrate in the former Soviet Union, Canada, North Slope of Alaska, South Sea Trough of Japan and Shenhu Sea of South China Sea, the problem of sand and water production cannot be avoided. The problems of sand production and water production in the process of natural gas hydrate depressurization exploitation have seriously restricted the exploitation efficiency and production of natural gas hydrate. The problems of sand production and water production are some of the main factors that prevent natural gas hydrate being commercially exploited. Therefore, it is urgent to carry out useful, relevant and cutting-edge research on the efficient drainage of sand and water from the wellbore in the process of natural gas hydrate mining. This paper innovatively proposes liquid-carrying and solid-carrying technology under foam circulation purging to address the existing problems of sand removal and drainage technology in hydrate mining. At present, no scholar has used this technology to solve the problem of sand removal and drainage in hydrate mining. Therefore, the research on efficient drainage is imperative. In this paper, We mainly studied the liquid-carrying and solid-carrying of vertical wellbore under the condition of foam cycle purging. We have revealed the relevant the liquid-carrying law and solid-carrying law through the above research.

The natural gas hydrate (NGH) reservoir in China is mainly distributed in the continental shelf with water depths ranging from 600–1500 m, about 90% of which is stored in the shallow area of the deep sea, with weak cementation and non-diagenetic characteristics. In order to test and study this type of NGH, samples must be prepared in situ, in large quantities, and at fast speed. At present, there are problems with the common stirring, spraying, and bubbling preparation techniques available, such as slow generation rate, low gas storage density, and lack of rapid preparation. Therefore, the rapid preparation of large samples of non-diagenetic natural gas hydrate has received extensive attention at home and abroad. In view of this technical bottleneck, Southwest Petroleum University innovatively established a rapid preparation kettle of 1062 L. In this paper, the preparation experiment of natural gas hydrate in the South China Sea (the pressure of the preparation kettle was reduced from 7 MPa to 3.3 MPa) was carried out in the preparation method of the ‘three-in-one’ (stirring method, spraying method, bubbling method) and experimental test method. In the process of preparation of non-diagenetic gas hydrate, the data of dynamic image, temperature, pressure, electrical resistivity, and reaction time are tested. During the preparation of natural gas hydrate, temperature, pressure, and electrical resistivity curves in four preparation methods were made, respectively. Through the experimental data analysis of different preparation methods of natural gas hydrate, it has been found that the preparation time of natural gas hydrate using the stirring method, the spraying method, and the bubbling method alone require a longer preparation time. However, when the three-in-one method is used to prepare natural gas hydrate, the preparation cycle of natural gas hydrate is obviously shortened. The preparation time of the single method of stirring method, spraying method, and bubbling method is respectively about 5.13, 3.59, and 3.37 times as long as that of three-in-one method. The three-in-one method for preparing natural gas hydrate greatly improves the preparation efficiency, which has a great significance to the scientific and technological progress of experimental research and evaluation methods of natural gas hydrate.