Young-Woo Heo

Prof. Dr. Young-Woo Heo

School of Materials Science and Engineering, Kyungpook National University, Daegu 41566, Korea

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 June 2017 in Materials
Verified
Journal Article
Open access
PDF file
INImas Noviyana
Imas Noviyana
ALAnnisa Dwi Lestari
Annisa Dwi Lestari
MPMaryane Putri
Maryane Putri
MWMi-Sook Won
Mi-Sook Won
JBJong-Seong Bae
Jong-Seong Bae
Hee Young LeeHee Young Lee
Hee Young Lee
Top-contact bottom-gate thin film transistors (TFTs) with zinc-rich indium zinc tin oxide (IZTO) active layer were prepared at room temperature by radio frequency magnetron sputtering. Sintered ceramic target was prepared and used for deposition from oxide powder mixture having the molar ratio of In2O3:ZnO:SnO2 = 2:5:1. Annealing treatment was carried out for as-deposited films at various temperatures to investigate its effect on TFT performances. It was found that annealing treatment at 350 °C for 30 min in air atmosphere yielded the best result, with the high field effect mobility value of 34 cm2/Vs and the minimum subthreshold swing value of 0.12 V/dec. All IZTO thin films were amorphous, even after annealing treatment of up to 350 °C.

8 July 2020 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
PHPham Tien Hung
Pham Tien Hung
PHPhung Dinh Hoat
Phung Dinh Hoat
VHVu Xuan Hien
Vu Xuan Hien
HLHee-Young Lee
Hee-Young Lee
SLSangwook Lee
Sangwook Lee
Young-Woo HeoYoung-Woo Heo
Young-Woo Heo

1 May 2005 in Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
Verified
Journal Article
Closed access
PDF file
CKChia Yang Kao
Chia Yang Kao
YKYong Wook Kwon
Yong Wook Kwon
Young-Woo HeoYoung-Woo Heo
Young-Woo Heo
DND. P. Norton
D. P. Norton
SPStephen Pearton
Stephen Pearton
GCG. C. Chi
G. C. Chi
ZnO thin film field effect transistors with 1.5–20μm gate width were fabricated using either a metal gate [metal–semiconductor field effect transistor (MESFET)] or a metal–oxide–semiconductor (MOS) gate. In both cases we found that use of a thick (∼0.8–0.9μm) ZnO buffer was necessary on the sapphire or glass substrate prior to growing the active layers in order to reduce gate leakage current. Source/drain contacts of e-beam deposited Ti∕Al∕Pt∕Au showed specific contact resistances of 2.18×10−6Ωcm2 without annealing and the interdevice isolation currents were ∼10μA at 40V bias. The MOS structure with 50nm (Ce,Tb)MgAl11O19 gate dielectric showed a 1 order of magnitude lower gate leakage current than the MESFET, due to the relatively low barrier height of metals on n-type ZnO (0.6–0.8eV). Good drain–source current characteristics were obtained from MOS gate structures using P-doped ZnO channels, whereas the metal structures showed very poor modulation.

1 June 2016 in Sensors and Actuators B: Chemical
Verified
Journal Article
Closed access
VHVu Xuan Hien
Vu Xuan Hien
Young-Woo HeoYoung-Woo Heo
Young-Woo Heo

30 December 2024 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
HLHyo-Jun Lim
Hyo-Jun Lim
TDThi Huong Thao Dang
Thi Huong Thao Dang
NLNayoon Lee
Nayoon Lee
SJSunwoo Jin
Sunwoo Jin
VVVan-Khoe Vo
Van-Khoe Vo
Young-Woo HeoYoung-Woo Heo
Young-Woo Heo

11 September 2024 in Nanophotonics
Verified
Journal Article
Open access
PDF file
NLNayoon Lee
Nayoon Lee
VVVan Khoe Vo
Van Khoe Vo
HLHyo‐Jun Lim
Hyo‐Jun Lim
SJSunwoo Jin
Sunwoo Jin
TDThi Huong Thao Dang
Thi Huong Thao Dang
Young-Woo HeoYoung-Woo Heo
Young-Woo Heo
This study reports on the fabrication of quantum dot light‐emitting diodes (QLEDs) with an ITO/Ni 1− x Mg x O/SAM/TFB/QDs/ZnMgO/Al structure and investigates the effects of various Mg doping concentrations in NiO on device performance. By doping Mg into the inorganic hole‐injection layer NiO (Ni 1− x Mg x O), we improved the band alignment with the hole‐injection layer through band tuning, which enhanced charge balance. Optimal Mg doping ratios, particularly a Ni 0.9 Mg 0.1 O composition, have demonstrated superior device functionality, underscoring the need for fine‐tuned doping levels. Further enhancements were achieved through surface treatments of Ni 0.9 Mg 0.1 O with UV‐Ozone (UVO) and thermal annealing (TA) of the ZnMgO electron transport layer. Consequently, by optimizing Mg‐doped NiO in QLED devices, we achieved a maximum external quantum efficiency of 8.38 %, a brightness of 66,677 cd/m 2 , and a current efficiency of 35.31 cd/A, indicating improved performance. The integration of Mg‐doped NiO into the QLED structure resulted in a device with superior charge balance and overall performance, which is a promising direction for future QLED display technologies.