The physicochemical properties, especially pH value of dental medicines, have significant influence on the health of oral cavity tissues. The pH of formulations should correspond to the value of saliva pH (5.5–8.0). For carbomer-based gels, the required pH value is obtained by neutralizing them with alkaline components, which leads to their structuring (thickening). This affects the physical properties of the gel, its residence time at the application site and the rate of release of active pharmaceutical ingredient. Therefore, the main purpose of this study is to evaluate the rheological, textural, and biopharmaceutical properties of Carbomer Polacril® 40P-based dental gel depending on the pH value. Evaluation of the rheological properties of gel preparations were performed by measuring the structural viscosity of the samples as a function of pH and temperature. The textural properties of the gel were evaluated by performing tests regarding back extrusion and spreadability. Carbomer Polacril® 40P-based gels haven’t shown noticeable thixotropic behavior, and were characterized by plastic flow in the whole studied pH range. The structural viscosity at the selected average pH value hasn’t differed at storage (25 °C) and application (37 °C) temperature. Texture studies of dental gels have shown a strong correlation with rheoparameters. Their rheological behavior and textural properties haven’t changed significantly between the pH range of 5.5–6.6. The relatively narrow range of working pH values does not affect the change in the viscosity of the preparation significantly and, consequently, does not affect the release of APIs from the developed Carbomer Polacril® 40P-based dental gel.
Black, brown, and light peat and sapropel were analyzed as natural sources of organic and humic substances. These specific substances are applicable in industry, agriculture, the environment, and biomedicine with well-known and novel approaches. Analysis of the organic compounds fulvic acid, humic acid, and humin in different peat and sapropel extracts from Lithuania was performed in this study. The dominant organic compound was bis(tert-butyldimethylsilyl) carbonate, which varied from 6.90% to 25.68% in peat extracts. The highest mass fraction of malonic acid amide was in the sapropel extract; it varied from 12.44% to 26.84%. Significant amounts of acetohydroxamic, lactic, and glycolic acid derivatives were identified in peat and sapropel extracts. Comparing the two extraction methods, it was concluded that active maceration was more efficient than ultrasound extraction in yielding higher amounts of organic compounds. The highest amounts of fulvic acid (1%) and humic acid and humin (15.3%) were determined in pure brown peat samples. This research on humic substances is useful to characterize the peat of different origins, to develop possible aspects of standardization, and to describe potential of the chemical constituents.
Spray-drying is the most popular encapsulation method used for the stabilization and protection of biologically active compounds from various environmental conditions, such as oxidation, moisture, pH, and temperature. Spray-drying increases the bioavailability of the natural active compounds and improves the solubility of low-soluble compounds. The aim of this work was to study the effects of different wall materials and optimize wall material solution’s composition on physicochemical properties of microcapsules loaded with phenolics, extract rich in volatile compounds and essential oil from Elsholtzia ciliata herb. For encapsulation of elsholtzia and dehydroelsholtzia ketones, more suitable wall materials were used—beta-cyclodextrin and sodium caseinate. Four phenolics—sodium caseinate, skim milk, beta-cyclodextrin, and resistant-maltodextrin—were used. A D-optimal mixture composition design was used to evaluate the effect of wall material solution’s composition using sodium caseinate (0.5–1 g), skim milk (6–10 g), resistant-maltodextrin (8–12 g), and beta-cyclodextrin (0.5–1 g) for the encapsulation efficiency, drying yield, and physicochemical properties. The optimal mixture composition was 0.54 g of sodium caseinate, 10 g of skim milk, 8.96 g of resistant-maltodextrin, and 0.5 g of beta-cyclodextrin. These encapsulating agents had a good performance in the microencapsulation of E. ciliata ethanolic extracts by the spray-drying technique. It is proven that the produced microparticles have a good potential to be included in various pharmaceutical forms or food supplements.
Myristica fragrans (f. Myristicaceae) seeds are better known as a spice, but their chemical compounds may have a pharmacological effect. The yield of their composition of extracts and essential oils differs due to different methodologies. The aim of this study was to evaluate an excipient material—magnesium aluminometasilicate—and to determine its influence on the qualitative composition of nutmeg extracts and essential oils. Furthermore, we wanted to compare the yield of essential oil. The extracts were prepared by maceration (M) and ultrasound bath-assisted extraction (UAE), and the essential oil—by hydrodistillation (HD). Conventional methods (UAE, HD) were modified with magnesium aluminometasilicate. The samples were analyzed by gas chromatography-mass spectrometry (GC-MS) method. From 16 to 19 chemical compounds were obtained using UAE with magnesium aluminometasilicate, while only 8 to 13 compounds were obtained using UAE without an excipient. Using our conditions and plant material, for the first time eight new chemical compounds in nutmeg essential oil were identified. Two of these compounds (γ-amorphene and cis-α-bergamotene) were obtained with the use of excipient, the other six (β-copaene, bergamotene, citronellyl decanoate, cubebol, cubenene, orthodene) by conventional hydrodistillation. Magnesium aluminometasilicate significantly increased the quantity of sabinene (from 6.53% to 61.42%) and limonene (from 0% to 5.62%) in essential oil. The yield of the essential oil from nutmeg seeds was significantly higher using magnesium aluminometasilicate; it increased from 5.25 ± 0.04% to 10.43 ± 0.09%.
The aim of this study was to determine the effects of pre-sowing seed treatment with cold plasma (CP) and an electromagnetic field (EMF) on the agricultural performance of two cultivars of common buckwheat (Fagopyrum esculentum Moench)—‘VB Vokiai’ and ‘VB Nojai’. For this, the effects of CP and EMF on seed germination, plant growth in the field, photosynthetic efficiency, biomass production, seed yield, and the amount of secondary metabolites and minerals in the harvested seeds were estimated. Although the percentage of seedlings that emerged under field conditions decreased by 11–20%, seed treatments strongly improved buckwheat growth and yield. Irrespective of differences in the dynamics of changes in the growth and photosynthetic activity between the two cultivars, the weight of seeds collected per plant for both cultivars was significantly higher (up to 70–97%) compared to the control. The biochemical composition of the harvested seeds (Fe, Zn, quercetin content) was also altered by seed treatments. Thus, pre-sowing treatment of buckwheat seeds with CP and EMF substantially stimulated plant growth in the field, increased biomass production, seed yield and nutritional quality. The results obtained strongly support the idea that plant seed treatment with physical stressors has great potential for use in agriculture.