Adaptive composite propeller blades showing bend twist behaviour have received increasing interest from hydrodynamic and structural engineers. When exposed to periodic loading conditions, such propellers can be designed to have higher energy efficiency and emit less noise and vibration than conventional propellers. This work describes a method to produce an adaptive composite propeller blade and how a point load experiment can verify the predicted elastic response in the blade. A 600 mm-long hollow full-size blade was built and statically tested in the laboratory. Finite element modelling predicted a pitch angle change under operational load variable loads of 0.55°, a geometric change that notably compensates for the load cases. In the laboratory experiment, the blade was loaded at two points with increasing magnitude. The elastic response was measured with digital image correlation and strain gauges. Model predictions and experimental measurements showed the same deformation patterns, and the twist angle agreed within 0.01 degrees, demonstrating that such propellers can be successfully built and modelled by finite element analysis.
This paper presents experimental and theoretical studies on the dynamic effect on the propeller loading due to ventilation by using a simulation model that generates a time domain solution for propeller forces in varying operational conditions. For ventilation modeling, the simulation model applies a formula based on the idea that the change in lift coefficient due to ventilation computes the change in the thrust coefficient. It is discussed how dynamic effects, like hysteresis effects and blade frequency dynamics, can be included in the simulation model. Simulation model validation was completed by comparison with CFD (computational fluid dynamics) calculations and model experiments. Experiments were performed for static and dynamic (heave motion) conditions in the large towing tank at the SINTEF Ocean in Trondheim and in the Marine Cybernetics Laboratories at NTNU (Norwegian University of Science and Technology). The main focus of this paper is to explain and validate the prediction model for thrust loss due to ventilation and out of water effects in static and dynamic heave conditions.
Four plausible design concepts are applied together to investigate composite bend–twist propeller-blade designs that show high twisting per bending deflection. The design concepts are first explained on a simplified blade structure with limited unique geometric features to determine generalized principles for applying the considered design concepts. Then, the design concepts are applied to another propeller-blade geometry to obtain a bend–twist propeller-blade design that achieves a specific pitch change under an operational loading condition with a significant periodic-load variation. The final composite propeller design shows several times more bend–twist efficiency than other published bend–twist designs and shows a desirable pitch change during the periodic-load variation when loaded with a one-way fluid–structure-interaction-derived load case. The high pitch change suggests that the design would mitigate undesirable blade effects caused by load variations on the propeller during operation.
Profilometry is proposed as a novel non-intrusive image-based technique to capture the profile of the air–water interface as a dense point cloud. It can be classified as an active stereo-vision method applied to the study of gravity-driven water waves and specifically developed to be used in large hydrodynamic laboratories. As an active vision technique, it relies on the use of light sources, and as a stereo technique, it requires one or more high-speed camera pairs for imaging the same scene synchronously. To enhance the visibility of the laser lights on the wave profile, the water surface is sprayed with water droplets. Profilometry, compared to standard wave probes, can be considered as an alternative source of information that can augment spatial resolution to the identification of the air–water interface to capture nonlinear wave-evolution mechanisms and violent wave–body interactions. Its feasibility and accuracy are examined preliminarily in a small-scale flume and then in a large-scale towing tank using long-crested wave scenarios, including regular, irregular, and focused gravity-driven waves, without the presence of a structure. The values of the wave steepness examined were various and included also quite steep cases with nearly vertical wave fronts. Role played by parameters of the technique, as well as of its setup in capturing the wave features are also analysed, with the aim to provide a useful guidance for other researchers that intent to use and develop further this approach.