Peter Gille

Prof. Peter Gille


Research Focus & Metrics

Academic Career Length

21Years (2006-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 January 2006 in Philosophical Magazine
Verified
Journal Article
Closed access
BBB. Bauer
B. Bauer
GMG. Meisterernst
G. Meisterernst
JHJ. Härtwig
J. Härtwig
Thomas SchenkThomas Schenk
Thomas Schenk
PGPeter Gille
Peter Gille
Large single crystals of the decagonal AlCoNi phase were reproducibly grown by the Czochralski method from Al-rich melts. By using native seeds, it was possible to grow crystals with well-defined orientations, e.g. along the 10-fold periodic axis or parallel to one of the 2-fold axes. Quasicrystals, that had been pulled in periodic or quasiperiodic directions, were characterized by X-ray transmission topography at the synchrotron source (ESRF) and at laboratory sources using the Lang technique. Because of the metallurgical homogeneity of the grown quasicrystals, lattice parameter differences did not contribute to the topographic contrast, instead, orientation contrast dominated. A column-like substructure along the periodic direction could be revealed. From this it is concluded that crystal growth along a two-fold direction might be favourable with respect to minimizing defect spreading.

21 February 2006 in Philosophical Magazine
Verified
Journal Article
Closed access
NMNilay K Mukhopadhyay
Nilay K Mukhopadhyay
ABA. Belger
A. Belger
PPPeter Paufler
Peter Paufler
PGPeter Gille
Peter Gille
This paper addresses some issues related to the nanomechanical responses of decagonal quasicrystals using nanoindentation techniques. A Hysitron Triboscope with a Berkovich indenter was used to carry out the nanoindentation tests on single crystals of Al–Co–Ni decagonal phase. The anisotropy in terms of nanohardness at higher load was observed, whereas it was not possible to establish the same at lower loads. However, the Young's modulus was found to be indistinguishable in all these cases. Discontinuity in load displacement, which is known as a ‘pop-in’ effect, was observed frequently at various load regime. It was found that this discontinuity was not due to cracking or a phase transformation effect, but to a plastic yielding phenomena and nanodeformation of the material. Significant differences between the nanohardness and microhardness were noticed and are discussed based on various experimental parameters and the consequent mechanical response of materials.

1 July 2009 in Journal of Alloys and Compounds
Verified
Journal Article
Closed access
PJP. Jeglič
P. Jeglič
MHM. Heggen
M. Heggen
MFMichael Feuerbacher
Michael Feuerbacher
BBB. Bauer
B. Bauer
PGPeter Gille
Peter Gille
FHF. Haarmann
F. Haarmann

1 May 2008 in Philosophical Magazine
Verified
Journal Article
Closed access
JDJanez Dolinsek
Janez Dolinsek
SVStanislav Vrtnik
Stanislav Vrtnik
ASA. Smontara
A. Smontara
MJM. Jagodič
M. Jagodič
ZJZ. Jagličić
Z. Jagličić
PGPeter Gille
Peter Gille
The anisotropic magnetic, electrical and thermal transport properties were studied of a single-crystalline Al80Cr15Fe5 approximant to the decagonal quasicrystal. The temperature-dependent electrical resistivity along the b and c crystalline directions shows non-metallic behaviour with a broad maximum, whereas it exhibits a metallic positive temperature coefficient along the a direction perpendicular to the (b, c) atomic planes. The resistivity can be treated with the model of slow charge carriers, where the increased electron–phonon scattering upon raising the temperature induces a transition from dominant Boltzmann (metallic) to dominant non-Boltzmann (insulating-like) regime. The magnetic susceptibility and thermal conductivity also reveal a small anisotropy.

16 September 2019 in Crystal Research and Technology
Verified
Journal Article
Open access
PDF file
KBKristian Bader
Kristian Bader
PGPeter Gille
Peter Gille
Single crystal growth and characterization of the binary semiconducting compound FeGa3 and its Ge‐substitute FeGa3–xGex are reported. Whereas there have been several investigations on the thermoelectric properties based on small samples grown by the flux method, this study is the first approach using the Czochralski growth technique from well‐oriented single‐crystalline seeds. Problems and solutions of the growth of cm3‐size single crystals are discussed in detail. Ge segregation in FeGa3–xGex is described by a segregation coefficient lower than unity which leads to an axially increasing Ge content along the pulling direction. Consequences with respect to lattice parameter changes and thermoanalytic measurements are reported.

22 February 2021 in Physical Review B
Verified
Journal Article
Open access
PDF file
MNM. Naumann
M. Naumann
PMP. Mokhtari
P. Mokhtari
ZMZ. Medvecka
Z. Medvecka
FAF. Arnold
F. Arnold
MPM. Pillaca
M. Pillaca
EHE. Hassinger
E. Hassinger
The unfilled skutterudite CoSb3 is a small-gap semiconductor which was predicted to be close to a strain-induced transition to a topological-insulator phase passing through a topological quantum critical point. As a starting point to strain measurements, the aim of this work is to characterize the electronic structure of as-grown samples. Two types of samples, one grown in Sb flux and the other by an inclined rotary Bridgman technique, are compared based on structural properties, resistivity, Hall effect, and magnetization. All samples appear metallic with small growth-dependent hole doping. Measurements of quantum oscillations in magnetization and angle-dependent electronic transport confirm the calculated band structure at ambient pressure. The Fermi surface consists of a single spherical sheet at the Γ point, and the purest samples grown by the Bridgman technique have a Fermi energy lying 25 meV below the valence-band edge. Band-structure calculations provide an accurate description of the experimental results. Hence, this compound is suitable for an investigation of topological states under strain.