PV (photovoltaic) capacity is steadily increasing every year, and the rate of increase is also increasing. A desert area with a large equipment installation area and abundant solar radiation is a good candidate. PV power plants installed in the desert have advantages in themselves, but when combined with desert aquacultures, additional benefits can be obtained while compensating for the shortcomings of the aquaculture industry. The importance of the aquaculture industry is increasing, with aquaculture products approaching half of the total supply of marine products due to sea environmental pollution and reduced resources. Moreover, in deserts, where marine products are difficult to obtain, aquaculture is a good way to save marine products. However, one of the many problems that complicate the introduction of aquaculture in the desert is that it is difficult to supply and demand electricity because the site is not near a viable electric grid. However, combination with PV can solve this problem. This paper investigates the solar power and aquaculture industry in the desert and explains the limitations and challenges of the solar power and aquaculture industry in the desert. Based on this, we hope to increase interest in the solar power and aquaculture industry in the desert and help with future research.

Every year, diverse types of safety accidents cause major damage to human life and property. In particular, failure to suppress safety accidents caused by fires during the early stages can lead to large-scale accidents, which in turn can cause more serious damage than other types of accident. Therefore, this paper presents an analysis of the prevailing research trends and future directions for research on preventing safety accidents due to fire. Since fire outbreaks can occur in many types of places, the study was conducted by selecting the places and causes involved in frequent fires, using fire data from Korea. As half of these fires were found to occur in buildings, this paper presents an analysis of the causes of building fires, and then focuses on three themes: fire prevention based on fire and gas detection; fire prevention in electrical appliances; and fire prevention for next-generation electricity. In the gas detection of the first theme, the gas referred to does not denote a specific gas, but rather to the gas used in each place. After an analysis of research trends for each issue related to fire prevention, future research directions are suggested on the basis of the findings. It is necessary to evaluate the risk, select a detection system, and improve its reliability in order to thoroughly prevent fires in the future. In addition, an active emergency response system should be developed by operating a fire prevention control system, and safety training should be developed after classifying the targets of the training targets appropriately.

Among the fire reports caused by seasonal devices registered with the Korea Fire Information Center in 2021, fires caused by heating cables accounted for the largest portion with 350 cases. As a result of analyzing the heating cable fires from 2015 to 2021, we have classified the heating cable fires into four types according to the method of winding the heating wire. First, we hypothesized that the temperature is high when the density is high due to the overlap of the hot wires or when there is a thermal insulating material. We predicted that the temperature would rise through a random game and established a reproducibility test plan. In order to check how heat generation changes depending on the winding method of antifreeze heating cables, we selected 10 manufacturers and checked the temperature characteristics according to the test conditions (Paragraph 11, Paragraph 19.101) of the Technical Regulations for Electrical and Telecommunication Products and Components of Korea (K 10013), tested the four methods mentioned in this thesis and compared and analyzed the results. The experiment results indicate that the temperature of the heater part in antifreeze heating cables was mostly higher than the conditions required by the existing standards in cases 1 to 4. In particular, in the case of No. 5 manufacturer’s sample, the temperature of the heating cable of Case 1 was measured to be the highest at 119.0 °C. In addition, as a result of applying the data engineering reproducibility test results in the framework of the random game λ proposed in this thesis, we have derived the same results as the predicted hypothesis. Case 1 refers to the case where a fire occurs due to the heating cable being wrapped around the water pipe and insulation or taped outside; It is one of the methods that users actually use a lot in the field. Based on experiment, we have concluded that the fire risk is high under the Case 1 condition. Thus, the test conditions in the existing K 10013 Standard need to be strengthened according to the Case 1 condition.

The Republic of Korea (ROK) has four distinct seasons. Such an environment provides many benefits, but also brings some major problems when using new and renewable energies. The rainy season or typhoons in summer become the main causes of inconsistent production rates of these energies, and this would become a fatal weakness in supplying stable power to the industries running continuously, such as the aquaculture industry. This study proposed an improvement plan for the efficiency of Energy Storage System (ESS) and energy use. Use of sodium-ion batteries is suggested to overcome the disadvantages of lithium-ion batteries, which are dominant in the current market; a greedy algorithm and the Floyd–Warshall algorithm were also proposed as a method of scheduling energy use considering the elements that could affect communication output and energy use. Some significant correlations between communication output and energy efficiency have been identified through the OPNET-based simulations. The simulation results showed that the greedy algorithm was more efficient. This algorithm was then implemented with C-language to apply it to the Test Bed developed in the previous study. The results of the Test Bed experiment supported the proposals.

A smart grid is an intelligent power grid. In recent years, the smart grid environment and its applications are incorporated into a variety of areas. The smart grid environment, however, can expose much more information than the old environments. In the environment, smart devices can be media in the exposure of various and specific pieces of information as well as energy consumption. This poses a huge risk in that it, combined with other pieces of information, may expose much more information. The current smart grid environment raises a need to develop anonymous signature and authentication techniques to prevent privacy breaches. Trying to meet this need, the principal investigator conducted research for three years. This paper discusses both the research trends investigated by him and the limitations of the development research and future research in need. Smart grid security requires the development of encrypted anonymous authentication that is applicable to power plant security, including nuclear power plants as well as expandable test beds.