Estimates of the frequency of metameric surfaces, which appear the same to the eye under one illuminant but different under another, were obtained from 50 hyperspectral images of natural scenes. The degree of metamerism was specified with respect to a color-difference measure after allowing for full chromatic adaptation. The relative frequency of metameric pairs of surfaces, expressed as a proportion of all pairs of surfaces in a scene, was very low. Depending on the criterion degree of metamerism, it ranged from about to for the largest illuminant change tested, which was from a daylight of correlated color temperature to one of . But, given pairs of surfaces that were indistinguishable under one of these illuminants, the conditional relative frequency of metamerism was much higher, from about to , sufficiently large to affect visual inferences about material identity.
In natural complex environments, the elevation of the sun and the presence of occluding objects and mutual reflections cause variations in the spectral composition of the local illumination across time and location. Unlike the changes in time and their consequences for color appearance and constancy, the spatial variations of local illumination color in natural scenes have received relatively little attention. The aim of the present work was to characterize these spatial variations by spectral imaging. Hyperspectral radiance images were obtained from 30 rural and urban scenes in which neutral probe spheres were embedded. The spectra of the local illumination at 17 sample points on each sphere in each scene were extracted and a total of 1904 chromaticity coordinates and correlated color temperatures (CCTs) derived. Maximum differences in chromaticities over spheres and over scenes were similar. When data were pooled over scenes, CCTs ranged from 3000 K to 20,000 K, a variation of the same order of magnitude as that occurring over the day. Any mechanisms that underlie stable surface color perception in natural scenes need to accommodate these large spatial variations in local illumination color.
If surfaces in a scene are to be distinguished by their color, their neural representation at some level should ideally vary little with the color of the illumination. Four possible neural codes were considered: von-Kries-scaled cone responses from single points in a scene, spatial ratios of cone responses produced by light reflected from pairs of points, and these quantities obtained with sharpened (opponent-cone) responses. The effectiveness of these codes in identifying surfaces was quantified by information-theoretic measures. Data were drawn from a sample of 25 rural and urban scenes imaged with a hyperspectral camera, which provided estimates of surface reflectance at 10-nm intervals at each of 1344 × 1024 pixels for each scene. In computer simulations, scenes were illuminated separately by daylights of correlated color temperatures 4000 K, 6500 K, and 25,000 K. Points were sampled randomly in each scene and identified according to each of the codes. It was found that the maximum information preserved under illuminant changes varied with the code, but for a particular code it was remarkably stable across the different scenes. The standard deviation over the 25 scenes was, on average, approximately 1 bit, suggesting that the neural coding of surface color can be optimized independent of location for any particular range of illuminants.
20 March 2019 in Journal of the Optical Society of America A
This tutorial offers an introduction to terrestrial and close-range hyperspectral imaging and some of its uses in human color vision research. The main types of hyperspectral cameras are described together with procedures for image acquisition, postprocessing, and calibration for either radiance or reflectance data. Image transformations are defined for colorimetric representations, color rendering, and cone receptor and postreceptor coding. Several example applications are also presented. These include calculating the color properties of scenes, such as gamut volume and metamerism, and analyzing the utility of color in observer tasks, such as identifying surfaces under illuminant changes. The effects of noise and uncertainty are considered in both image acquisition and color vision applications.