A hand control movement is composed of several ballistic movements. The time required in performing a ballistic movement and its endpoint variability are two important properties in developing movement models. The purpose of this study was to test potential models for predicting these two properties. Twelve participants conducted ballistic movements of specific amplitudes using a drawing tablet. The measured data of movement time and endpoint variability were then used to verify the models. This study was successful with Hoffmann and Gan's movement time model (Hoffmann, 1981; Gan and Hoffmann 1988) predicting more than 90.7% data variance for 84 individual measurements. A new theoretically developed ballistic movement variability model, proved to be better than Howarth, Beggs, and Bowden's (1971) model, predicting on average 84.8% of stopping-variable error and 88.3% of aiming-variable errors. These two validated models will help build solid theoretical movement models and evaluate input devices. Practitioner summary: This article provides better models for predicting end accuracy and movement time of ballistic movements that are desirable in rapid aiming tasks, such as keying in numbers on a smart phone. The models allow better design of aiming tasks, for example button sizes on mobile phones for different user populations.
The corrective reaction time (tcr) is an essential motor property when modelling hand control movements. Many studies designed experiments to estimate tcr, but reported only group means with inconsistent definitions. This study proposes an alternative methodology using Drury's (1994) intermittent illumination model. A total of 24 participants performed circular tracking movements under five levels of visual information delay using a modified monitor in a darkened room. Measured movement speeds and the manipulated delays were used with the model to estimate tcr of individuals and test effects of gender and path width. The results showed excellent model fits and demonstrated individual differences of tcr, which was 273 ms on average and ranged from 87 to 441 ms. The wide range of tcr values was due to significant effects of gender and path width. Male participants required shorter tcr compared to female participants, especially for narrow path widths. This study reports the corrective reaction time (tcr) of individuals using a novel methodology. The estimated tcr ranged from 87 to 441 ms, helping model hand control movements, such as aiming and tracking. The methodology can be continuously applied to study tcr under conditions with various performers and movements.
Perceived exertion and discomfort have been used extensively in ergonomics practice. Job incumbents typically rate their exertion on scales such as Borg's rated perceived effort (RPE) and their discomfort on scales such as Corlett and Bishop's body part discomfort scales (BPD). This study asks whether exertion and discomfort can be perceived by an external observer, i.e. is vicarious perception possible? Four participants (targets) performed 20 postural holding tasks selected from Ovako Working Posture Analysing System postures and gave RPE and BPD scores for each posture. Video clips of each target in each posture were shown to four expert ergonomists and 23 novices, who also gave RPE and BPD scores. Correlations between targets and observers scores were high, with significance exceeding p = 0.01. Observers were generally conservative, rating easy postures too high and difficult postures too low. All observers rated female targets higher than male targets. Female observers rated all targets higher then male observers. Vicarious perception of discomfort and exertion was possible, but there was not a one-to-one correspondence to ratings given by those experiencing the posture.
1 July 2018 in The American Journal of Emergency Medicine