This paper proposes a novel stress measurement method using the acoustoelastic effect of surface wave to estimate the stress of a homogeneous material plate with orthogonal anisotropy, in which the surface wave velocities are measured in three different directions before and after loading stress. The effectiveness of the proposed method was verified by numerical simulations and experiments. For the simulations, the surface wave velocities in three directions were obtained from a conventional perturbation model for weak anisotropic materials. The simulation results showed that the stress estimation error was less than 3% for an anisotropic rate up to 2% under stress conditions up to 90 MPa. Two specimens were prepared for the experiments, one was almost isotropic and another that had a relatively larger anisotropy rate of 2.6%. Then, the stresses loaded by a tensile test machine were estimated. The results showed good agreement with the given stresses for both specimens. These results confirm that the proposed method can be applied to estimate the surface stress state in anisotropic material plates. The proposed method is simple, practical, and is expected to be useful for monitoring changes of surface stress before and after machining such as the punching or bending of plate.
30 March 2023 in Nuclear Engineering and Technology
The structures in high-temperature environments are prone to undergo hardening and embrittlement as a result of thermal aging; this can cause variations in their mechanical properties. Because these changes occur at the microstructural level, it is difficult to evaluate them through linear ultrasonic techniques. In this work, a surface acoustic wave (SAW) was used to measure and compare the acoustic nonlinearity and mechanical properties of Al6061 alloys heat-treated at 220 °C for different durations (0 min, 20 min, 40 min, 1 h, 2 h, 10 h, 100 h, 1000 h). The SAW was generated by a pulsed laser and then received by an interferometer. Moreover, the yield strength, ultimate strength, and elongation to failure were measured by tensile tests. The results demonstrate that the critical variations in the mechanical properties can be detected by monitoring the variation features in the acoustic nonlinearity. Transmission electron microscopy images were captured to observe the microstructural changes, which shows that the acoustic nonlinearity varied according to the change in the precipitation phase. This supports the acoustic nonlinearity measurement using the laser-generated SAW being an effective technique for the fully noncontact nondestructive evaluation of material degradations as well as changes in mechanical properties.
This paper proposes an indirect method to measure absolute acoustic nonlinearity parameters using surface acoustic waves by employing a fully non-contact laser-ultrasonic technique. For this purpose, the relationship between the ratio of relative acoustic nonlinearity parameters measured using the proposed method in two different materials (a test material and a reference material) and the ratio of absolute acoustic nonlinearity parameters in these two materials was theoretically derived. Using this relationship, when the absolute nonlinearity parameter of the reference material is known, the absolute nonlinearity parameter of the test material can be obtained using the ratio of the measured relative parameters of the two materials. For experimental verification, aluminum and copper specimens were used as reference and test materials, respectively. The relative acoustic nonlinearity parameters of the two materials were measured from surface waves generated and received using lasers. Additionally, the absolute parameters of aluminum and copper were measured using a conventional direct measurement method, with the former being used as a reference value and the latter being used for comparison with the estimation result. The absolute parameter of copper estimated by the proposed method showed good agreement with the directly measured result.