A good knowledge of the quality of the satellite soil moisture products is of great importance for their application and improvement. This paper examines the performance of eight satellite-based soil moisture products, including the Soil Moisture Active Passive (SMAP) passive Level 3 (L3), the Soil Moisture and Ocean Salinity (SMOS) Centre Aval de Traitement des Données SMOS (CATDS) L3, the Japan Aerospace Exploration Agency (JAXA) Advanced Microwave Scanning Radiometer 2 (AMSR2) L3, the Land Parameter Retrieval Model (LPRM) AMSR2 L3, the European Space Agency (ESA) Climate Change Initiative (CCI) L3, the Chinese Fengyun-3B (FY3B) L2 soil moisture products at a coarse resolution of ~0.25°, and the newly released SMAP enhanced passive L3 and JAXA AMSR2 L3 soil moisture products at a medium resolution of ~0.1°. The ground soil moisture used for validation were collected from two well-calibrated and dense networks, including the Little Washita Watershed (LWW) network in the United States and the REMEDHUS network in Spain, each with different land cover. The results show that the SMAP passive soil moisture product outperformed the other products in the LWW network region, with an unbiased root mean square (ubRMSE) of 0.027 m³ m⁻³, whereas the FY3B soil moisture performed the best in the REMEDHUS network region, with an ubRMSE of 0.025 m³ m⁻³. The JAXA product performed much better at 0.25° than at 0.1°, but at both resolutions it underestimated soil moisture most of the time (bias < −0.05 m³ m⁻³). The SMAP-enhanced passive soil moisture product captured the temporal variation of ground measurements well, with a correlation coefficient larger than 0.8, and was generally superior to the JAXA product. The LPRM showed much larger amplitude and temporal variation than the ground soil moisture, with a wet bias larger than 0.09 m³ m⁻³. The underestimation of surface temperature may have contributed to the general dry bias found in the SMAP (−0.018 m³ m⁻³ for LWW and 0.016 m³ m⁻³ for REMEDHUS) and SMOS (−0.004 m³ m⁻³ for LWW and −0.012 m³ m⁻³ for REMEDHUS) soil moisture products. The ESA CCI product showed satisfactory performance with acceptable error metrics (ubRMSE < 0.045 m³ m⁻³), revealing the effectiveness of merging active and passive soil moisture products. The good performance of SMAP and FY3B demonstrates the potential in integrating them into the existing long-term ESA CCI product, in order to form a more reliable and useful product.

In this study, the Standardized Precipitation Evaporation Index (SPEI) was applied to characterize the drought conditions in Southwest China from 1982–2012. The SPEI was calculated by precipitation and temperature data for various accumulation periods. Based on the SPEI, the multi-scale patterns, the trend, and the spatio-temporal extent of drought were evaluated, respectively. The results explicitly showed a drying trend of Southwest China. The mean SPEI values at five time scales all decreased significantly. Some moderate and severe droughts were captured after 2005 and the droughts were even getting aggravated. By examining the spatio-temporal extent, the aggravating condition of drought was further revealed. To investigate the performance of SPEI, correlation analysis was conducted between SPEI and two remotely sensed drought indices: Soil Moisture Condition Index (SMCI) and Vegetation Condition Index (VCI). The comparison was also conducted with the Standardized Precipitation Index (SPI). The results showed that for both SMCI and VCI, the SPI and SPEI had approximate correlations with them. The SPEI could better monitor the soil moisture than the SPI in months with significant increase of temperature. The correlations between the VCI and SPI/SPEI were lower; nevertheless, the SPEI was slightly superior to the SPI.

The spatiotemporal distribution of soil moisture over the Tibetan Plateau is important for understanding the regional water cycle and climate change. In this paper, the surface soil moisture in the northeastern Tibetan Plateau is estimated from time-series VV-polarized Sentinel-1A observations by coupling the water cloud model (WCM) and the advanced integral equation model (AIEM). The vegetation indicator in the WCM is represented by the leaf area index (LAI), which is smoothed and interpolated from Terra Moderate Resolution Imaging Spectroradiometer (MODIS) LAI eight-day products. The AIEM requires accurate roughness parameters, which are parameterized by the effective roughness parameters. The first halves of the Sentinel-1A observations from October 2014 to May 2016 are adopted for the model calibration. The calibration results show that the backscattering coefficient (σ°) simulated from the coupled model are consistent with those of the Sentinel-1A with integrated Pearson’s correlation coefficients R of 0.80 and 0.92 for the ascending and descending data, respectively. The variability of soil moisture is correctly modeled by the coupled model. Based on the calibrated model, the soil moisture is retrieved using a look-up table method. The results show that the trends of the in situ soil moisture are effectively captured by the retrieved soil moisture with an integrated R of 0.60 and 0.82 for the ascending and descending data, respectively. The integrated bias, mean absolute error, and root mean square error are 0.006, 0.048, and 0.073 m³/m³ for the ascending data, and are 0.012, 0.026, and 0.055 m³/m³ for the descending data, respectively. Discussions of the effective roughness parameters and uncertainties in the LAI demonstrate the importance of accurate parameterizations of the surface roughness parameters and vegetation for the soil moisture retrieval. These results demonstrate the capability and reliability of Sentinel-1A data for estimating the soil moisture over the Tibetan Plateau. It is expected that our results can contribute to developing operational methods for soil moisture retrieval using the Sentinel-1A and Sentinel-1B satellites.

This paper presents a microwave/optical synergistic methodology to retrieve soil moisture in an alpine prairie. The methodology adequately represents the scattering behavior of the vegetation-covered area by defining the scattering of the vegetation and the soil below. The Integral Equation Method (IEM) was employed to determine the backscattering of the underlying soil. The modified Water Cloud Model (WCM) was used to reduce the effect of vegetation. Vegetation coverage, which can be easily derived from optical data, was incorporated in this method to account for the vegetation gap information. Then, an inversion scheme of soil moisture was developed that made use of the dual polarizations (HH and VV) available from the quad polarization Radarsat-2 data. The method developed in this study was assessed by comparing the reproduction of the backscattering, which was calculated from an area with full vegetation cover to that with relatively sparse cover. The accuracy and sources of error in this soil moisture retrieval method were evaluated. The results showed a good correlation between the measured and estimated soil moisture (R² = 0.71, RMSE = 3.32 vol.%, p < 0.01). Therefore, this method has operational potential for estimating soil moisture under the vegetated area of an alpine prairie.

Soil moisture is a pivotal hydrological variable that links the terrestrial water, energy, and carbon cycles. In this article, a new soil moisture (SM) index (SMI), which aims to capture the temporal variability of SM, irrespective of cloud cover and solar illumination, was developed by using the L-band SM active passive (SMAP) radiometer observations. The SMI was proposed on the basis of two key foundations: 1) vegetation and roughness have similar effects on ``depolarization'' of microwave emission, while SM enhances polarization differences and 2) vegetation and roughness generally impose positive effects on surface emissivity, while SM and emissivity are negatively correlated. Based on the two physical principles, it is possible to decouple the effects of SM and those of vegetation and surface roughness in a 2-D space independent of vegetation type and roughness condition. The proposed SMI was then validated by in situ measurements from five dense SM networks covering different vegetation and climatic conditions and also compared with SMAP passive and European space agency climate change initiative (ESA CCI) SM products at a coarse resolution of 36 km, and SMAP-enhanced passive and Japan Aerospace Exploration Agency (JAXA) advanced microwave scanning radiometer (AMSR2) SM products at a medium resolution of 9 km. The results show that the new SMI is able to well reproduce the temporal dynamic of SM with a favorable averaged correlation coefficient value of 0.87 and 0.84 at 36 and 9 km, respectively, higher than that of SMAP passive (0.80), SMAP-enhanced passive (0.77), ESA CCI (0.69), and JAXA AMSR2 (0.53). After removing the systematic differences between satellite and site-specific SM data by using the cumulative distribution function (CDF) matching technique, the SMI can achieve an average root mean squared error (RMSE) of 0.031 and 0.036 m³m⁻³ at 36 and 9 km during the validation period, respectively, lower than that of the satellite SM products. In addition to surface temperature, the SMI does not need any further information from other sensors [e.g., the optical normalized difference vegetation index (NDVI) or leaf area index (LAI) data] to guarantee an all-weather monitoring. Therefore, it has great potential to estimate SM variability on a global scale.

Soil moisture is an essential variable in the land surface ecosystem, which plays an important role in agricultural drought monitoring, crop status monitoring, and crop yield prediction. High-resolution radar data can be combined with optical remote-sensing data to provide a new approach to estimate high-resolution soil moisture over vegetated areas. In this paper, the Sentinel-1A data and the Moderate Resolution Imaging Spectroradiometer (MODIS) data are combined to retrieve soil moisture over agricultural fields. The advanced integral equation model (AIEM) is utilized to calculate the scattering contribution of the bare soil surface. The water cloud model (WCM) is applied to model the backscattering coefficient of vegetated areas, which use two vegetation parameters to parameterize the scattering and attenuation properties of vegetation. Four different vegetation parameters extracted from MODIS products are combined to predict the scattering contribution of vegetation, including the leaf area index (LAI), the fraction of photosynthetically active radiation (FPAR), normalized difference vegetation index (NDVI), and the enhanced vegetation index (EVI). The effective roughness parameters are chosen to parameterize the AIEM. The Sentinel-1A and MODIS data in 2017 are used to calibrate the coupled model, and the datasets in 2018 are used for soil moisture estimation. The calibration results indicate that the Sentinel-1A backscattering coefficient can be accurately predicted by the coupled model with the Pearson correlation coefficient (R) ranging from 0.58 to 0.81 and a root mean square error (RMSE) ranging from 0.996 to 1.401 dB. The modeled results show that the retrieved soil moisture can capture the seasonal dynamics of soil moisture with R ranging from 0.74 to 0.81. With the different vegetation parameter combinations used for parameterizing the scattering contribution of the canopy, the importance of suitable vegetation parameters for describing the scattering and attenuation properties of vegetation is confirmed. The LAI is recommended to characterize the scattering properties. There is no obvious clue for selecting vegetation descriptors to characterize the attenuation properties of vegetation. These promising results confirm the feasibility and validity of the coupled model for soil moisture retrieval from the Sentinel-1A and MODIS data.