Tackling issues of implantation-caused defects and contamination, this paper presents a new complementary metal–oxide–semiconductor (CMOS) image sensor (CIS) pixel design concept based on a native epitaxial layer for photon detection, charge storage, and charge transfer to the sensing node. To prove this concept, a backside illumination (BSI), p-type, 2-µm-pitch pixel was designed. It integrates a vertical pinned photo gate (PPG), a buried vertical transfer gate (TG), sidewall capacitive deep trench isolation (CDTI), and backside oxide–nitride–oxide (ONO) stack. The designed pixel was fabricated with variations of key parameters for optimization. Testing results showed the following achievements: 13,000 h+ full-well capacity with no lag for charge transfer, 80% quantum efficiency (QE) at 550-nm wavelength, 5 h+/s dark current at 60 °C, 2 h+ temporal noise floor, and 75 dB dynamic range. In comparison with conventional pixel design, the proposed concept could improve CIS performance.
This paper presents a new charge coupled device (CCD) based on capacitive deep trench isolation (CDTI), developed in CMOS technology. The 2 phase device features collection, storage and transfer in the silicon volume. Full Well Charge (FWC) of about 2.6ke-/μm2 and Charge Transfer Inefficiency (CTI) below 1×10–4 have been measured via electrical charge injection on pixels with pitches ranging from 12 to 48μm.
1 December 2012 in IEEE Transactions on Nuclear Science
1.4μm pixel pitch CMOS Image sensors based on hole collection pinned photodiode (HPD) have been irradiated with 60 Co source. The HPD sensors exhibit much lower dark current degradation than equivalent commercial sensors using an Electron collection Pinned Photodiode (EPD). This hardness improvement is mainly attributed to carrier accumulation near the interfaces induced by the generated positive charges in dielectrics. The pre-eminence of this image sensor based on hole collection pinned photodiode architectures in ionizing environments is demonstrated.
This work presents a new type of Charge Coupled Device (CCD) manufactured using a CMOS process and featuring Capacitive Deep Trench Isolation (CDTI). The device is used in a Multi-Pinned Phase mode (MPP) enabling almost constant oxide interface passivation. Flatband shift, Dark current and Charge Transfer Inefficiency (CTI) induced by Total Ionizing Dose (TID) are investigated. Despite the increase of interface states, results show that dark current can be efficiently mitigated by use of short charge transfer duration, avoiding full interface depletion and free charge generation. It is further shown that trapping by interface states is only lightly affecting CTI as the Buried Channel keeps electrons far from interfaces. Finally, a clear correlation on flatband shift with Full Well Charge (FWC) reduction is established.
In this letter, we present global shutter pixel using active deep trench isolation gate to transfer and to store photodiode charge signal into a fully depleted pinned MOS capacitance. This architecture is compatible with the conventional Correlated Double Sampling (CDS). Global Shutter (GS) readout noise lower than 2e- is demonstrated. The fully depleted pinned capacitance is able to store 12ke- with dark current lower than 25e-/s at 60°C. Global shutter efficiency, better than 99.96% at 550nm, is reported.