Deformation of a direct quenched type of ultra-high strength steel (UHSS) with low-carbon content is studied in this work. Although this material, as manufactured, combines high strength and good ductility, it is highly sensitive to the workshop fabrication processes used. The presence of stress concentration due to structural discontinuity or notch effects can accentuate the effect of fabrication processes on the deformation capacity of the material. To evaluate the influence of fabrication methods on deformation capacity, a series of tensile tests are done on both pure base material (BM) and after the steel has been subjected to heat input (HI) or cold forming (CF). To study the effect of HI due to welding or other heat-based workshop fabrication processes, the surface of the material was dressed by laser beam at controlled speed and laser intensity. CF effects were studied by bending the specimens to a predetermined angle prior to subjecting the steel to tensile testing. Experimental results were compared with numerical simulation using ls-dyna simulation software. The generated results show acceptable agreement between experimental and numerical simulation outcomes.
20 July 2016 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
The low-cycle fatigue behavior of a direct-quenched ultra-high-strength steel was experimentally characterized and numerically modeled. Fatigue and cyclic parameters were obtained by conducting strain-controlled low-cycle fatigue tests on uniform-gage specimens. Surface residual stresses were minimized and axial deflection eliminated by optimization of machining parameters and post-machining electro-polishing. The steel material showed cyclic softening and decrease in yield strength. Cyclic softening, stabilized response, and the cyclic stress–strain curve were numerically simulated using finite element analysis with a model capable of describing nonlinear kinematic-isotropic hardening. The results showed good agreement with experimental values and validated the model’s ability to simulate the softening and cyclic stabilization of the material under investigation. The same numerical method was then used in elasto-plastic stress–strain analysis of notched specimens made of the same material to make fatigue life predictions. Estimated lives were compared with predictions made by analytical approximations such as the linear rule, Neuber’s rule, and the strain energy density method and verified by experimental data. Finite element analysis using stabilized cyclic response yields the most accurate predictions and, thus, provides an effective tool for the fatigue analysis of this material.