A biomimetic semi-activated oscillating-foil device with multiple foils in a parallel configuration is studied for the extraction of marine renewable energy. For the present investigation, an unsteady boundary element method (BEM) is used for the simulation of 3D lifting flows. For this work, the device is assumed to be submerged far from the free surface and the sea bottom. However, the geometry of the body and the initial shape of the wake are general. For the numerical simulations, a high performance in-house GPU-accelerated code (GPU-BEM) is developed. For the calculation of singular integrals, an adaptive algorithm based on the Gauss–Lobatto quadrature is used. Concerning the numerical scheme of GPU-BEM, the convergence of the method was tested, the numerical characteristics were determined and the method was validated. A parametric study of a single-foil device is presented to determine the performance characteristics of such devices. Next, twin-foil devices are investigated in parallel and staggered configurations with a phase difference between the two foils. Finally, the multiple-foil parallel configuration is compared against turbines. After enhancement and further verification, the present method is proposed for the design and control of such biomimetic devices for the extraction of energy from waves and tidal currents nearshore.

The propagation and transformation of water waves over varying bathymetries is a subject of fundamental interest to ocean, coastal and harbor engineers. The specific bathymetry considered in this paper consists of one or two, naturally formed or man-made, trenches. The problem we focus on is the transformation of an incoming solitary wave by the trench(es), and the impact of the resulting wave system on a vertical wall located after the trench(es). The maximum run-up and the maximum force exerted on the wall are calculated for various lengths and heights of the trench(es), and are compared with the corresponding quantities in the absence of them. The calculations have been performed by using the fully nonlinear water-wave equations, in the form of the Hamiltonian coupled-mode theory, recently developed in Papoutsellis et al (Eur. J. Mech. B/Fluids, Vol. 72, 2018, pp. 199-224). Comparisons of the calculated free-surface elevation with existing experimental results indicate that the effect of the vortical flow, inevitably developed within and near the trench(es) but not captured by any potential theory, is not important concerning the frontal wave flow regime. This suggests that the predictions of the run-up and the force on the wall by nonlinear potential theory are expected to be nearly realistic. The main conclusion of our investigation is that the presence of two tandem trenches in front of the wall may reduce the run-up from (about) 20% to 45% and the force from 15% to 38%, depending on the trench dimensions and the wave amplitude. The percentage reduction is greater for higher waves. The presence of only one trench leads to reductions 1.4 - 1.7 times smaller.