The charging process of water droplets in different electrification systems using empirical and numerical analysis is described. A simplified model based on capacitance distribution is proposed. The results of the experimental studies and numerical calculations enable comparison of the induction and conduction charging methods in terms of the droplet charging level, described by the Q/m parameter. Research findings indicate that the conduction method in a 3-electrode system is the most effective among all the considered methods. It has been also shown that the application of a 2-electrode system under certain conditions provides greater Q/m parameter values in comparison to the system with three electrodes using the induction method. The research results can be used to develop charging systems (e.g., nozzles) that produce streams with electrically charged liquid particles.
The paper discusses the applicability and advantages of using electrically charged soap bubbles as a route to produce fine sprays composed of highly charged particles, commonly named as electroaerosols. It is indicated that such low in energy demand process may produce very fine droplets or particulates charged to a level higher than that obtained using classical spray charging techniques, involving no bubbles. A process of a soap bubble electrical charging is thus initially studied on a simple analytical basis pointing out to a possibility of producing air bubbles with charge-to-mass (Q/m) ratio up to 60 mC/kg (constrained by the Rayleigh limit) while just 2 mC/kg is commonly considered as a threshold value for an effective particle charging process. Finite element 3D electrostatic simulation method (3D FEM) is then applied to assess a single bubble charging level achievable in a laboratory setup using a DC high-voltage biased bubble machine producing soap bubbles 23 mm in diameter on average. The 3D FEM simulation results postulate a single bubble maximum charging level approaching 25 nC at 41.5 kV charging voltage (constrained by the Rayleigh limit), corresponding to (Q/m) = 17.6 mC/kg. Finally, a stream of bubbles characterized by (Q/m) = 10.4 mC/kg was produced experimentally in the laboratory setup using a contact charging method at 40 kV DC supply. A discrepancy between 3D FEM-simulated results and experimental data was discussed on a shielding effect basis. Graphic
31 August 2018 in Fibres & Textiles in Eastern Europe
The aim of the research was to set up a simplified analytical fabric-grounded object model for estimation of the energy stored in the electric field occurring in the space surrounding a charged fabric. A standard spherical electrode was used as the grounded object. Synthetic fabric with regularly spread conductive yarns (in the form of a grid with regular cells) was used as a sample. The model allowed to combine the energy stored in the space of the cell with the geometry of the fabric-object system and the surface charge density. The model led to a power type relation between the energy W and the cell, with a diameter of a, in the form W = K∙ an, n ≈ 3. These results were verified by those obtained from numerical modeling using the COMSOL Multiphysics program. It was found that for a cell with a diameter of 10 to 50 mm, the difference in results was lower than 38%. Based on the results obtained, it can be stated that the model proposed can be used for the design of fabrics (used in ESD protection) with the maximum acceptable stored energy.
Wydawnictwo SIGMA-NOT wydaje czasopisma fachowe informuj?ce swoich czytelnik?w o najnowszych osi?gni?ciach naukowych i nowoczesnych rozwi?zaniach technicznych w Polsce i na ?wiecie, popularyzuje problemy techniczne oraz poszerza wiedz? i kultur? techniczn?.