Nano-fertilisers have only recently been introduced to intensify plant production, and there still remains inadequate scientific knowledge on their plant-related effects. This paper therefore compares the effects of two nano-fertilisers on common sunflower production under field conditions. The benefits arising from the foliar application of micronutrient-based zinc oxide fertiliser were compared with those from the titanium dioxide plant-growth enhancer. Both the zinc oxide (ZnO) and titanium dioxide (TiO₂) were delivered by foliar application in nano-size at a concentration of 2.6 mg·L⁻¹. The foliar-applied nanoparticles (NPs) had good crystallinity and a mean size distribution under 30 nm. There were significant differences between these two experimental treatments in the leaf surfaces’ trichomes diversity, ratio, width, and length at the flower-bud development stage. Somewhat surprisingly, our results established that the ZnO-NPs treatment induced generally better sunflower physiological responses, while the TiO₂-NPs primarily affected quantitative and nutritional parameters such as oil content and changed sunflower physiology to early maturation. There were no differences detected in titanium or zinc translocation or accumulation in the fully ripe sunflower seeds compared to the experimental controls, and our positive results therefore encourage further nano-fertiliser research.

It has been shown that the foliar application of inorganic nano-materials on cereal plants during their growth cycle enhances the rate of plant productivity by providing a micro-nutrient source. We therefore studied the effects of foliarly applied ZnO nanoparticles (ZnO NPs) on Setaria italica L. foxtail millet’s quantitative, nutritional, and physiological parameters. Scanning electron microscopy showed that the ZnO NPs have an average particle size under 20 nm and dominant spherically shaped morphology. Energy dispersive X-ray spectrometry then confirmed ZnO NP homogeneity, and X-ray diffraction verified their high crystalline and wurtzite-structure symmetry. Although plant height, thousand grain weight, and grain yield quantitative parameters did not differ statistically between ZnO NP-treated and untreated plants, the ZnO NP-treated plant grains had significantly higher oil and total nitrogen contents and significantly lower crop water stress index (CWSI). This highlights that the slow-releasing nano-fertilizer improves plant physiological properties and various grain nutritional parameters, and its application is therefore especially beneficial for progressive nanomaterial-based industries.

Nanotechnology offers new opportunities for the development of novel materials and strategies that improve technology and industry. This applies especially to agriculture, and our previous field studies have indicated that zinc oxide nanoparticles provide promising nano-fertilizer dispersion in sustainable agriculture. However, little is known about the precise ZnO-NP effects on legumes. Herein, 1 mg·L⁻¹ ZnO-NP spray was dispersed on lentil plants to establish the direct NP effects on lentil production, seed nutritional quality, and stress response under field conditions. Although ZnO-NP exposure positively affected yield, thousand-seed weight and the number of pods per plant, there was no statistically significant difference in nutrient and anti-nutrient content in treated and untreated plant seeds. In contrast, the lentil water stress level was affected, and the stress response resulted in statistically significant changes in stomatal conductance, crop water stress index, and plant temperature. Foliar application of low ZnO-NP concentrations therefore proved promising in increasing crop production under field conditions, and this confirms ZnO-NP use as a viable strategy for sustainable agriculture.

In environmental and agronomic settings, even minor imbalances can trigger a range of unpredicted responses. Despite the widespread use of metal-based nanoparticles (NPs) and new bio-nanofertilizers, their impact on crop production is absent in the literature. Therefore, our research is focused on the agronomic effect of spray application of gold nanoparticles anchored to SiO₂ mesoporous silica (AuSi-NPs), zinc oxide nanoparticles (ZnO-NPs), and iron oxide nanoparticles (Fe₃O₄-NPs) on sunflowers under real-world environments. Our findings revealed that the biosynthetically prepared AuSi-NPs and ZnO-NPs were highly effective in enhancing sunflower seasonal physiology, e.g., the value of the NDVI index increased from 0.012 to 0.025 after AuSi-NPs application. The distribution of leaf trichomes improved and the grain yield increased from 2.47 t ha⁻¹ to 3.29 t ha⁻¹ after ZnO-NPs application. AuSi-NPs treatment resulted in a higher content of essential linoleic acid (54.37%) when compared to the NPs-free control (51.57%), which had a higher determined oleic acid. No NPs or residual translocated metals were detected in the fully ripe sunflower seeds, except for slightly higher silica content after the AuSi-NPs treatment. Additionally, AuSi-NPs and NPs-free control showed wide insect biodiversity while ZnO-NPs treatment had the lowest value of phosphorus as anti-nutrient. Contradictory but insignificant effect on physiology, yield, and insect biodiversity was observed in Fe₃O₄-NPs treatment. Therefore, further studies are needed to fully understand the long-term environmental and agricultural sustainability of NPs applications.

On a daily basis, a wide range of materials including inorganic nanoparticles (NPs) inadvertently find their way into the environment. Meanwhile, intentionally used NPs, such as the new generation of nanofertilizers (NFs) are designed to enhance agronomic production. However, their physicochemical properties and not-so-well understood effects raise potential risks to the plant reproductive cycle, specifically pollen development, a subject largely absent in academic research. Even slight contamination, deformation, or aberration of pollen could have enormous impacts on the ecosystem. Thus, our objective was to evaluate the influence of various metal-based NPs on sunflower pollen morphology and its yield. Nano-formulations were applied during the 2019–2021 agronomic seasons on two sunflower hybrids, Neostar and Edison, in Dolná Malanta, near Nitra, Slovak Republic. Pollen morphology findings indicated that conventional ZnSO₄ had the most positive impact on the size of pollen grains compared to ZnO-NPs, Fe₃O₄-NPs, and the NP-free control. Gold-NPs on SiO₂ mesoporous silica (AuSi-NPs) showed a statistically insignificant impact, while the use of TiO₂-NPs in agriculture remained a topic of debate. Surprisingly, pollen characteristics did not fully correspond to crop yields. Despite causing a reduction in pollen grain size, the TiO₂-NPs consistently showed the highest yield compared to other variants. Employing low concentrations of NFs did not notably alter pollen morphology, reinforcing our commitment to eco-friendly, precise, and sustainable agriculture.

The worldwide steep rise of vegetable oil consumption creates an urgency to improve oilseed crop yield. Sesame ( Sesamum indicum L.) is called the “Queen of Oilseeds” due to the voluminous presence of several vitamins, minerals, antioxidants, and beneficial fatty acids; the oil is considered safe for consumption. It is widely cultivated in the tropical and subtropical regions throughout the world. However, compared to other oilseed crops, the meagre yield of sesame largely hampers its successful commercialisation. The major problems associated with this crop are early pod shattering and susceptibility to various abiotic and biotic stresses. Biotechnology-mediated crop improvement is a good alternative to slow, labour-intensive, and cumbersome conventional breeding methods. Worldwide efforts can be observed to improve targeted traits of this crop using modern biotechnological tools. However, the lack of a well-accepted regeneration and transformation protocol is the major burden in implementing biotechnological yield improvement methods in sesame, especially transgenesis-mediated gene manipulation techniques. In this review, we discussed the growth and cultivation scenario of sesame. We also depicted the important problems associated with low crop yield. Next, we represented the current progress of regeneration and associated transgenesis-mediated gene manipulation research in sesame. We also briefed on the importance of sesame whole-genome sequencing. Finally, we presented a concise discussion on the available potential genes, regulatory elements, DNA markers, and QTLs that can be used in gene manipulative and marker-assisted selection-based yield improvement programmes. Information presented in this review article could potentially be utilised for yield improvement research in sesame.