The social acceptance of biogas is often hampered by environmental and health concerns. In this study, the current knowledge about the impact of biogas technology is presented and discussed. The survey reports the emission rate estimates of the main greenhouse gases (GHG), namely CO₂, CH₄ and N₂O, according to several case studies conducted over the world. Direct emissions of gaseous pollutants are then discussed, with a focus on nitrogen oxides (NO_x); evidences of the importance of suitable biomass and digestate storages are also reported. The current knowledge on the environmental impact induced by final use of digestate is critically discussed, considering both soil fertility and nitrogen release into atmosphere and groundwater; several case studies are reported, showing the importance of NH₃ emissions with regards to secondary aerosol formation. The biogas upgrading to biomethane is also included in the study: with this regard, the methane slip in the off-gas can significantly reduce the environmental benefits.

Social acceptance has proven to be a significant barrier in the implementation of renewable energy systems (hereinafter “RES”). While a general acceptance of RES is high, low local acceptance has hindered the development of renewable energy projects (hereinafter “REP”). This study assesses the determinants of local and general social acceptance of REP across Europe through a qualitative analysis from 25 case studies of the most significant social drivers and barriers that include all European countries. These case studies contain qualitative and quantitative analyses of the main factors for social acceptance of many representative groups including residents, stakeholders, and experts. Understanding the influences of social acceptance enables us to create strategies that will promote the development of REP by mitigating any public opposition.

Drying is a critical point for the exploitation of biomass for energy production. High moisture content negatively affects the efficiency of power generation in combustion and gasification systems. Different types of dryers are available however; it is known that rotary dryers have low cost of maintenance and consume 15% and 30% less in terms of specific energy. The study analyzed the drying process of woody residues using a new prototype of mobile rotary dryer cocurrent flow. Woodchip of poplar (Populus spp.), black locust (Robinia pseudoacacia L.), and grapevine (Vitis vinifera L.) pruning were dried in a rotary drier. The drying cycle lasted 8 h for poplar, 6 h for black locust, and 6 h for pruning of grapevine. The initial biomass had a moisture content of around 50% for the poplar and around 30% for grapevine and black locust. The study showed that some characteristics of the biomass (e.g., initial moisture content, particle size distribution, bulk density) influence the technical parameters (i.e., airflow temperature, rate, and speed) of the drying process and, hence, the energy demand. At the end of the drying process, 17% of water was removed for poplar wood chips and 31% for grapevine and black locust wood chips. To achieve this, result the three-biomass required 1.61 (poplar), 0.86 (grapevine), and 1.12 MJ kg_{dry solids}⁻¹ (black locust), with an efficiency of thermal drying (η) respectively of 37%, 12%, and 27%. In the future, the results obtained suggest an increase in the efficiency of the thermal insulation of the mobile dryer, and the application of the mobile dryer in a small farm, for the recovery of exhaust gases from thermal power plants.