In this paper, the hydraulic efficiency optimization calculation method of a ten-stage centrifugal pump is researched. According to the hydraulic loss model, a multi-objective optimization calculation method based on surrogate models is proposed. In order to study the highly nonlinear relationship between key design variables and centrifugal pump external characteristic values, this paper builds the quadratic response surface, the radial basis Gaussian response surface, and Kriging three surrogate models using computer fluid dynamics (CFD) simulation analysis. Two types of calculation models (hydraulic loss model and three surrogate models) combined NSGA-Π genetic algorithm are applied to optimize the key design variables and to find the optimal solution of each model. The accuracy and effectiveness of the efficiency optimization methods based on the two types of calculation models are compared and analyzed. The results show that the calculation method of hydraulic loss model based on the semitheoretical and semi-empirical formula is less time-consuming but inaccurate. In contrast, the optimization method based on surrogate models using CFD simulation is accurate. What's more, comparing the surrogate models, the results based on the complete quadratic response surface model which make the efficiency of the first stage centrifugal pump reach 77.26% are more accurate.
A multi-objective prediction method of multi-stage pump method based on neural network with data augmentation is proposed. In order to study the highly nonlinear relationship between key design variables and centrifugal pump external characteristic values (head and power), the neural network model (NN) is built in comparison with the quadratic response surface model (RSF), the radial basis Gaussian response surface model (RBF), and the Kriging model (KRG). The numerical model validation experiment of another type of single stage centrifugal pump showed that numerical model based on CFD is quite accurate and fair. All of prediction models are trained by 60 samples under the different combination of three key variables in design range respectively. The accuracy of the head and power based on the four predictions models are analyzed comparing with the CFD simulation values. The results show that the neural network model has better performance in all external characteristic values comparing with other three surrogate models. Finally, a neural network model based on data augmentation (NNDA) is proposed for the reason that simulation cost is too high and data is scarce in mechanical simulation field especially in CFD problems. The model with data augmentation can triple the data by interpolation at each sample point of different attributes. It shows that the performance of neural network model with data augmentation is better than former neural network model. Therefore, the prediction ability of NN is enhanced without more simulation costs. With data augmentation it can be a better prediction model used in solving the optimization problems of multistage pump for next optimization and generalized to finite element analysis optimization problems in future.