The lean manufacturing concept is a systematic minimization of waste and non-value activities in production processes introduced by the Toyota production system. In this research, lean manufacturing is implemented in a cement production line. Value Stream Mapping (VSM) is applied to give a clear picture of the value chain in cement production processes and to highlight the non-value-added in the shop floor. To begin, the existing VSM is constructed based on the information and data gathered during visiting and observing the manufacturing process in the firm. As a result, the excess inventory between workstations was identified as a major waste generation, hence, the proposed VSM conducts further improvement and makes action plans to alleviate the unwanted activities. Then, the takt time to ensure smooth material flow and to avoid any occurring delay or bottleneck in the production line was figured out. The supermarket pull-based production control is suggested to be adopted in the future map. Two pull production strategies are selected in this case. The first is applying the Kanban system to control the level of inventory between workstations. The other is the CONWIP approach to control the amount of work in process to the entire production line. The outcome of the proposed models indicates a decrease of the none-value time from 23 days in the current state to about 4 and 2 days in Kanban and CONWIP systems respectively, so the CONWIP was suggested as most efficient. Some suggestions for further research are also mentioned.
A methodology of modeling chip geometry of flat helical end milling based on a variable flow stress machining theory is presented in this article. The proposed model is concerned with the variation of the width of cut thickness. The nonuniform chip thickness geometry is discretized into several segments based on the radial depth of cut. The chip geometry for each segment is considered to be constant by taking the average value of the maximum and minimum chip thickness. The maximum chip thickness for each chip segment is computed based on the current width of cut, feed per tooth and the cutter diameter. The subsequent radial depth of cut is subtracted from the discretized size of the width of cut to obtain the minimum chip thicknesses. The forces for each segment are summed to obtain the total forces acting on the system of the workpiece and the tool. The cutting forces can be predicted from input data of work material properties, cutter configuration and the cutting conditions used. The validation of the proposed model is achieved by correlating experimental results with the predicted results obtained.