In order to suppress the overpressure and flame damage caused by the explosion of premixed methane-air, a self-built duct with a 10 × 10 × 100 cm was used to conduct an experimental study on the explosive characteristics and propagation rules of 9.5% methane under the effect of different porous materials at a fixed position. The methods of suppressing methane-air explosion in confined space are optimized. By analyzing the effect of porosity and distance of the porous material on the explosion, the overpressure and flame propagation characteristics after the methane-air explosion and under the influence of the dual factors are studied. It provides data support to explain the mechanism of blocking and suppressing premixed methane-air explosion when porous materials with different porosity and different positions. Studies have shown that the different porosity of porous materials and the position from the explosion source have significant and different effects on the propagation of overpressure and flame. The 10 PPI porous material has a strong promoting effect on the overpressure and flame propagation after the explosion, it accelerates the overpressure rising rate and increases the overpressure peak, and enhances the turbulence intensity of the explosion flame and accelerates the flame propagation rate. The 20 PPI porous material failed to suppress the explosion during the acceleration phase, but had certain suppression on the explosion flame in other phases. The effect of 30 PPI porous material to suppress explosion overpressure and flame depends on where it is placed. Both 20 PPI and 30 PPI porous materials can quench the flame and block the propagation of high-temperature carbonaceous products. This research results have theoretical value and guiding significance for the prevention and emergency treatment of methane explosion accidents.
5 February 2020 in International Journal of Coal Science & Technology
In order to avoid serious safety accidents caused by closed fire zone, based on the continuous monitoring of atmospheric pressure at different monitoring points in multiple mines, the atmospheric pressure fluctuation model and the air leakage model were established and analyzed. The change law with time of oxygen concentration and gas concentration in the fire zone were obtained due to atmospheric disturbances under the influence of different pressure difference, volume and size of fire area, wind resistance, gas emission, sealing moments, etc. so as to evaluate the explosion risk of a closed fire zone. Research showed that the mine atmosphere fluctuates with the atmosphere of ground, and the pressure difference between the inner and outer sides of the enclosed fire zone is affected by the periodic fluctuation of atmosphere, which has about 16-h cosine fluctuation and approximate 8-h fixed value. Compared with the fire zone with poor sealing quality, good sealing fire zone has better resistance to atmospheric disturbance. The reduction of oxygen concentration in the inner side of a well-sealed fire zone mainly depends on the dilution of methane, which is more likely to accumulate and rise rapidly. And the fire zone with poor sealing quality is easy to be interfered. The inner oxygen concentration and gas concentration are easily affected by the absolute gas emission and the air leakage in the fire zone. Fire zone with small wind resistance and small volume is especially obvious. At the initial stage of the closed fire zone it's very possible to happen explosion. The time duration of explosion danger varies under different conditions, and the atmospheric disturbance may lead to repeated explosions in some cases. It's suggested to take some methods to avoid explosions according to the real-time situation, closure time, oxygen concentration and gas concentration of fire zone.