New analytical approaches to the simultaneous identification and quantification of 94 pesticides and 13 polycyclic aromatic hydrocarbons (PAHs) in five representative matrices (pepper, apple, lettuce, wheat, and soil) were developed. The analyses were based on gas chromatography coupled with triple quadrupole tandem mass spectrometry (GC-MS/MS). The procedure was optimized by changing the solvent used during the extraction, from acetonitrile to the acetone: n-hexane mixture at a volume ratio of 1:4 (v/v), as well as the use of a reduced amount of water during the extraction of compounds from cereals. An additional modification was the use of florisil instead of GCB in the sample cleanup step. A full method validation study was performed, at two concentration levels (LOQ and 1000 × LOQ), which showed satisfactory results for all analytes from the PAHs group, with recoveries ranging from 70.7–115.1%, and an average RSD of 3.9%. Linearity was tested in the range of 0.001–1.000 mg/kg and showed coefficients of determination (R²) ≥ 0.99 for all PAHs. Satisfactory recovery and precision parameters (LOQ and 100 × LOQ) were achieved for almost all analytes from the pesticide group in the range of 70.1–119.3% with the mean RSD equal to 5.9%. The observed linearity for all analytes in the concentration range of 0.005–1.44 mg/kg was R² ≥ 0.99, with the exception of famoxadone, chizalofop-p-ethyl, prothioconazole, spirodiclofen, tefluthrin, and zoxamid. The extended uncertainties were estimated, using a top-down approach of 9.9% (average) and 15.3% (average) for PAHs and pesticides samples, respectively (the coverage factor k = 2, the 95% confidence level). Ultimately, the method was successfully applied to determine pesticide residues in commercial samples of fruit, vegetables and grain, and soil samples for PAHs, which were collected from selected places in the Podkarpacie region. A total of 38 real samples were tested, in which 10 pesticides and 13 PAHs were determined. Proposed changes allow us to shorten the sample preparation time (by 20%) and to reduce the consumption of organic solvents (by 17%). The use of florisil for sample cleanup, instead of GCB, improves the recovery of compounds with flat particles.

In plant protection, biological preparations are used alternately with chemical pesticides. The applied microorganism can influence the concentration of chemical substances. Laboratory and field studies were conducted to assess the influence of Bacillus subtilis and Trichoderma harzianum on the penthiopyrad concentration. In laboratory studies, the effectiveness of penthiopyrad degradation by B. subtilis was approximately 5% during 14 days of the experiment. For penthiopyrad treated with T. harzianum strains, the degradation effectiveness ranged from 34.2% on Day 3 to 56.9% on Day 14. In experiments testing the effects of mixed culture of microorganisms, the effectiveness of penthiopyrad degradation ranged from 23.7% on Day 3 to 29.1% on Day 14. After treatment of apple trees of Gala and Golden Delicious varieties with a biological preparation, a maximum degradation of penthiopyrad of 20% was found in both varieties. Samples of apples were prepared by the quick, easy, cheap, effective, rugged and safe (QuEChERS) method, and penthiopyrad was analyzed by gas chromatography with a mass detector. A determined value of the chronic exposure to penthiopirad was 1.02% of the acceptable daily intake, both for children and for adults. The acute exposure amounted to 7.2% and 1.9% of the acute reference dose for children and adults, respectively. These values were considered to be acceptable and not threatening to health.

This investigation was undertaken to determine whether active ingredients (AIs) of currently recommended plant protection products (PPPs) could be transferred to beehives from apple and pear trees. A field trial was carried out with apple trees of Ligol and Idared variety, and pear trees of Conference variety. For pest and diseases control of fungal origin, recommended PPPs were applied. Samples of flowers from the above-mentioned varieties of fruit trees, of bees, brood and honey from beehives located in their direct neighborhood were collected regularly and analyzed for the presence of lambda-cyhalothrin (an insecticide) and cyprodinil, captan, fluopyram, kresoxim-methyl, penthiopyrad and trifloxystrobin (fungicides). In samples of flowers of Ligol variety, fluopyram residues (on average 0.621 µg single flower⁻¹) were at the highest levels, whereas in samples of pear flowers of Conference variety, and in flowers of Idared variety, captan residues (on average, respectively, 0.705 and 165.7 µg single flower⁻¹). In samples of bees and honey, residues of five AIs were detected, and in brood six AIs, whereby in each case captan residues prevailed, respectively, up to 585.2, 51.52 and 126.5 µg kg⁻¹ bees and honey. In the honey, significantly larger residues of captan were found out than maximum residue level (MRL) for this AI – 103.04% MRL. In the case of any AI, the daily intake did not exceed 0.002% acceptable daily intake (ADI).