N-nitrosamines, which are well-known pro-mutagens, are found in drugs, pickled food and tobacco. Therefore, controlling their concentrations is very important. When an HPLC, GC or NMR analysis is conducted to investigate certain asymmetrical N-nitrosamines, two sets of signals attributed to the asymmetric N-nitrosamine isomers are usually observed. However, few reports on the NMR assignment of asymmetrical N-nitrosamine isomers have been published. In this study, we investigated the NMR assignments of the Z/E isomers of six asymmetrical N-nitrosamines by means of density functional theory (DFT) calculations. The configuration of the major isomer of asymmetrical N-nitrosamine 3 was the Z-configuration. The configuration of the major isomers of asymmetrical N-nitrosamines 4–7 was the E-configuration. Then, we determined the Z/E ratios of these asymmetrical N-nitrosamines by means of variable temperature (VT) and room temperature (RT) 1H-NMR experiments. The ratios of the Z/E isomer 3 quickly increased beyond 100% in the VT 1H NMR experiments. The ratios of Z/E isomers 4–7 were increased in the range of 10–60% in the VT 1H NMR experiments. The results of this study indicate that identifying the isomers of asymmetrical N-nitrosamine is necessary to control the quality of N-nitrosamines for active pharmaceutical ingredients (APIs).
Estrogens in personal care products are harmful to customers. Conventional methods such as HPLC and LC-MS require tedious sample pretreatment and long analytical time. Paper-spray ionization mass spectrometry (PSI-MS) is a powerful tool for the determination of compounds with little time and minimal pretreatment procedures. Since most estrogens show poor responses in PSI-MS, we developed a chemical derivatization and PSI-MS method to determinate three estrogens: estradiol, estriol and ethinyloestradiol with estradiol valerate as the internal standard (I.S.). After derivatization with 2-fluoro-1-methyl-pyridinium-p-toluene-sulfonate, the three estrogens could be quantified in seconds. This method showed good linearity in the range of 0.1~30 μg·mL−1, with R2 > 0.999. Their recovery results were all between 85%~115%. The limits of detection (LOD) were 0.04 μg·mL−1, 0.02 μg·mL−1 and 0.02 μg·mL−1 for estradiol, estriol and ethinyloestradiol respectively, which improved around 200, 2000, and 900 times compared to non-derivative PSI-MS. The method could quantitatively determine estrogens in cosmetics.
Application of liquid chromatography-mass spectrometry (LC-MS) in analyzing the content of alfacalcidol tablets dissolution faces big challenges due to the low amount of alfacalcidol in each tablet and the low ionization efficacy of the compound with electrospray ionization (ESI) or atmospheric-pressure chemical ionization (APCI). Here, extraction, derivatization, and LC-MS quantitation method have been developed and validated for measuring alfacalcidol tablets dissolution content. After alfacalcidol dissolution solution was extracted with dichloromethane to remove surfactant and inorganic salts, alfacalcidol was then derivatized via a Cookson reagent, 4-phenyl-1, 2, 4-triazoline-3, 5-dione (PTAD), under ambient conditions. Alfacalcidol derivative was successfully analyzed by LC-MS. Limit of detection (LOD) of the derivatized alfacalcidol was improved 100 times (0.01 μg/mL) compared with the nontreated compound (1 μg/mL). The new method was then validated following International Conference on Harmonization (ICH) guidance. The method shows a good linearity with r2 > 0.99. Interday and intraday reproducibility was 3.3% and 7.9%, respectively. This procedure can be used in quantification of alfacalcidol tablets dissolution content and corresponding pharmaceutical quality control.